Somethings you could check....
Check the front bumper side supports, make sure it's not rusted/broken/loose. Check the brake calipers - see if you can slide the arm in/out...mine jingles when i hit bumps.
For the rear - check the suspension support/bumper on the shocks, I have a piece that came...
It should be the original one....at least when I got the car it came with it. Also the spare is a 16in. I have used the spare before, but on the rear tires and it worked fine. The spare does seem to be scratched on the inside, but only a small part of it, not the entire diameter of the spare...
I didn't have too much time/light to check things out, but I did notice that the top outer corner of the caliper is scratched, shiney, and I tried manually turning the spare wheel and it does get stuck and grind...I took off the wheel and checked the rotor and it turns fine.....I'll see if I can...
Just tonight, my front left (driver's side) tire went flat. I pulled over to change it using the original 16 in. spare tire. Once installed I start driving and hear a scraping noise. I pulled over and pulled off the spare. For some odd reason it seems the spare is scraping against the top outer...
My whole dash was recently removed to get it painted. Got everything reinstalled, but now some gauges do not work: water temp, RPM, oil pressure. Turbo gauge, speedometer work fine. I checked the connections behind the dashboard and they seem to be ok and the fuse (below driver side kickpanel is...
Sooo besides from Turkish being hairy...
is thesupraforums.com related to supraforums.com?
Thesupraforums.com is "The Premier Online Supra Society" yeah!!!!
Man I live down here in Costa Rica...the land of pot holes. I tried asking around here for a water pump for my car. The only place i can get it from is from a local toyo dealer = ~$90 and it would take about 2 weeks to get here.
I need to replace my water pump since it's leaking from the weep hole. I wanted to know what causes it to leak from there. I'm guessing there is a rubber? seal that goes and causes it to leak; but besides from that the seal covers the bearings too? So if the seal goes bad, then water gets into...
I'll have to make sure to inspect and most likely replace my injector o-rings.
You have to dip the o-rings in fuel to install them onto the injectors and when seating the injectors in/on to engine?
On a side note: Is it normal to get shocked when touching one of the spark plug wires while...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.