Search results

Hello, I am curious if my IAC can cause a boost leak by having a breather on it rather than being plumbed back into the intake pipe? I assume this would cause a boost leak unless the IAC can get 100% sealed under boost, which I doubt. Any thoughts?

Hey folks, I am looking to get some paint on my hooptie, curious if shine auto project is still the place for my turbo A duct / and bomex sides and rear bumper? Any hints on who makes quality aero, not trying to rice here and wiggle down the HW.

Hey everyone, im curious what vacuum people are pulling at idle with a single and 272s? ~Scott

Hey folks, im pig rich at idle, just fired it with only the intake manifold no IC piping. Its off the gauge rich at idle running mkiv 550s and 1jz map. I figured the o2 sensor would handle the idle even with 550s. Is this normal or do i need to trouble shoot, resistor installed and no...

ive go my tranny out, and clutch disk out. Note Im using a spec stage 3 here. I need to swap the pressure plate to my 1j R-154. Can i get the pressure plate out without removing the bell housing? TSRM doesnt make mutch sense to me. I asssume i can remove those snap rings and pull all the...

Whats up folks. I was curious if anyone has had sucess running an auto aristo ecu with a r154 for their 2jz swap? I wanna go 2j, but if i have to get a jdm MT harness, and ecu thats gonna be a bitch. Any sugguestions besides stand alone or 1.5 jz? ~scott

can I use a 89+ harness and ecu on a pre 89 7mgte? Sorry for cross post, i should have just posted here where the smart people are. ~scott

I just got SAFC II, and after reading the manual a few times I got an idea. I'll give some background info before I continue. SAFC II reads throttle position based on a 0 to 5 volt input. based on these inputs a high and low throttle position are selected, and VF readings from the AFM are...

Hey, I have been having problems with my '87. It Idles great, and revs smoothly when not under load (IE in neutral) When I get around 3k rpm I feel vibrations in the petals and shifter, not super violent, but something to let me know that Ive got a miss or something. I have 0 codes. My...

After I installed my wideband I am running lean under boost. 13 lbs, with 550s and lexus, stock FPR and stock pump. My timing was too advanced, by alot. Now I want to set it at 10 deg. Once i get it set at 10 i remove the jumper t1 and e1 my timing does not jump up to 12 as described as tsrm? I...

My wideband goes off the chart on the rich side for the first 15 miles or so every time i get a full tank of gas, and come down to idle. Any ideas on what this is caused by, after a few miles problem goes away, and i sit right around 14.7 at idle? Stock fuel pump, and no AFPR, I do have 550s...

I cant see my fuel filter, I thought it would be under the intake manifold, but its not! Cant find it on tsrm, anyone got a pic? ~scott

Hey, i'm running real rich, black smoke when letting off throttle, and smelly! I Have 550s and lexus. I wanna lean her out with out using a piggyback. I need to pass smawg! Will my lexus screw help me achieve this or is messing with the screw a bad call? ~scott

what is needed from PLX devices to make my autometer AF gauge to output wideband data? I beleive all i need is a translator box, and WB o2 sensor. Is there anything else. Is it possible to replace the stock o2 directly, and translate to NB for the ECU, then back to WB after the ECU? Anyone...

For all of j00Z that have creeeezy maAaAd TyzzziyTe JDM poses post em up! Me first. ~scott

Well i finally hit the 500 mile mark on my engine. No rodknock as of yet, w00t. I was in stockton yesterday running to errands at Mustangs Plus. (yes i own a dumbestic) and on the way i raced a 300z tt. From a stop i was owning, in 1st and by 2nd i had 1/2-1/4 car on him. Thats all there...