Search results

HUH question mark question mark

Copper plugs were around before platinum and iridiums were ever dreamed of. Some of those cars you listed probably had coppers in them and you didn't even know :biglaugh: That said: Fully rebuilt bottom end to TSRM spec: Balanced rods, shot peened. New pistons (oversize to the next...

Do the 360's have SSD drives?

So I guess the OP never checked this??

Ever checked up on the Solid State Discs? I KNOW those will load faster, but $800.00 at the minimum for a 120GB hard drive?? Fuck that.

Oh, another one of "these" threads...

Depends on what you're using yours for ;) I'll be putting a lot of demos,trailers, movies, and music on mine. From the one review I've read where someone actually put one in thier PS3, they stated that loading and saving from the hard drive times were cut in half due to the 16MB memory...

Anyone on here upgraded their hard drive? I'm looking at the Hitachi 7K200 series 200GB hard drive. I think it's the world's fastest laptop HD currently... Any takers?

You don't have to if you Drill out the restriction inside of it. If you leave it on and have a Walbro fuel pump with stock FPR, then you risk damaging the FPR due to the restriction in the j-tube keeping the fuel from flowing back to the tank enough without backing up the lines with excess fuel...

Oh my, when did this rumor start?

I've seen this before on Hondas, an IC on an NA, but a supra??? For shame :nono:

I would buy them if they came with flow charts...

Gorgeous example of a MKIII done right :) PM a mod and see if they would consider having you making a short HOW-TO thread on what a AFPR install should look like and have it placed in the tech section. They may allow that as it should help some people out.

This fucking sucks, I just bouth mine a few months ago.

Looks like his was going to the J-tube... Most people remove that and do what you did.

Do you have a FFIM? Do you plan on getting one? If both are "no", then you should opt for an intercooler that has the inlet and outlet on the SAME SIDE. As far as what size piping you'll be going with, take a look at my thread in the SME section title "how much does the 7M breathe under...

OT, damn nice looking motor posted above ;).

150 degree or 30 degree, however you want to look at it.

IC and hardpipes.

If I had to do it over again, my first one would have been auto.