Search results

gte block all the way ---------- Post added at 02:53 PM ---------- Previous post was at 02:52 PM ---------- let me rephrase. More like a lot closer to 30 lbs ---------- Post added at 02:53 PM ---------- Previous post was at 02:53 PM ---------- no issues or problems

Opening this thread again. I was wondering what are the biggest width of tires I can put on these rims? If I like what I see I will keep the rims and put them on with wheel spacers like what Tweet just did. Largest width in the rear and largest width in the front. Here are the pics of the...

OMG You have saved my life. I was going crazy with the timing on my car. Thanks a lot.

same rims I have. What are the size of the spacers. And are they completely flush with the top of the fender

I get my oil done at a shop here in conroe. And the owner is a toyota specialist. Well I know i hear a lot about it. But its 20w50... I know already. But he says because of the hot weather and the type of car I should use that weight.. I told him that if anything happens to my motor because...

cool thanks I feel better now. I run about 30-40psi a 2000rpms in 5th gear

if anyone would know. What is the normal oil pressure at operating temperature and idle on a turbo supra. unshimmed oil pump? I'm running in between 0 and 20 more close to 0 than 20

I'm planning on doing a full race application

cold start injector. In the middle of the intake on the bottom of the plenum

If all else fails use the dye and a uv black light

right under the intake on cylinders 2 or 3. And this Its the little hole above the freeze plug Cylinder 5 below the freeze plug is the one in the back

If you want to. I pulled both of my motors to change the head gaskets.

Straight up or wiggle and jiggle or pull the studs first. ---------- Post added at 03:20 PM ---------- Previous post was at 03:17 PM ---------- oh yeah studs? You can't take the head off the motor with the motor in the bay unless you remove the studs and then pull the head off. Then on...

green is really the one you should be looking more towards. Green is a knock sensor plug ( most likely the front ) and the two brown ones look like the plugs that go to your two VSV's under the intake manifold

well I went and got my shims off my other head. So now I have a total of 48 shims and buckets. That should be enough to do a valve job right. I measured all 24 shims that I have out and now I just have to successfully perform the valve job. I'm actually not going to do it today. I have no...

He is a fellow supra owner right?

SRZMK3 your right. Also the 90 degree 5/8 hose on the pass side that connects to the front main from the pipe on the side of the block. I had mine leaking there and never saw it until I got shot in the face when is burst. Also there are two hoses on your TB and two on your IAC and one on the...

Not many valve shims are left available. I was told by my Toyota parts guy (JJ) that I would have to wait at least 2-3 weeks for any to come in.

why does zumtizzle seem like hes mad at me?

Are you running water or coolant? Coolant has a greater boiling temp than water. What could be happening is the water in your radiator is boiling and creating pressure, too much for the radiator cap to handle, and releasing it into the overflow tank until the high pressure from boiling over is...