Search results

I'm around 4k+ for my 2jzgte swap on stock twins... 2jzge = 500-1000 Manifold = 100-250 Turbo = 500-1000 vs 2jzgte = 2000-2500 in engine alone. and u still are not sure of the condition of the turbos. Honestly if my car started out as a turbo 7mgte, na-t is the direction i wouldve taken. I...

they should have a few clips and double sided tape. Just pull them off carefully and youll be okay.

na-t is deff the best bang for your buck. Id say go for 2jzge and turbo it

Does no one look through this thread for info? You need a rear sump setup for your supra.

pics of said cars? Welcome!

- Straight from Tweaked Perf, hope this might help others. Hello, The plug in the first picture is your O2 sensor. You need to run a USDM 4-pin O2 sensor with this connector. The second picture is your EFI noise filter. This sensor is not necessary for the engine to run properly, but you...

needs moar low :p so dem honda boys how its done xD, lol jkjkjk

i sent tweaked an email, waiting for reply..

pics or it didnt happen o.0?

i bought my shift boot and ebrake cover from them like last week o.0! Says its gonna take 10-20 days :<

Have a thread on it lol. http://www.supramania.com/forums/showthread.php?157262-Need-to-identify-3-plugs-on-my-harness-to-finish-my-2jz-swap!-Help-is-appreciated-lt-3

Yeahh, didnt think anyone would bump haha. Installed new fuel pump, mounted ps, ac lines, and throttle cable. I ran the harness through the dash. Just need intercooler piping, get a new tps, figure out where 2 plugs from my harness go and i should be good to go. Thanks :), the interior kinda...

I was searching and found that plug #2 might be a noise filter? http://www.supraforums.com/forum/showthread.php?452396-WTF-is-that-harness-clip-under-the-igniter http://www.supraforums.com/forum/showthread.php?274118-HKS-DLI-Install anyone have any suggestions for the third plug? 1st is...

dam k20, sick car. You should deff pm ur # so we can meet up some time haha, my car should be done soon.

^ ditto i need one, fuck the stock canister. Any pics of the drop :P? Andy for Prez!

dam, so where do i go about finding one? Do i need it before i try starting the engine up?

dont see it D:, but what does that plug do/for?

http://imageshack.us/photo/my-images/97/lb7fcea4416ac41a98766f5.jpg/ Found this looking around? My ignitor bracket did not have that plug? Could that be where plug #2 goes? Also what purpose does it serve?

My harness was done by Dr. Tweaked. Just need to find out where/what a few plugs are. Thanks in advance. First Plug #1. Located Near the Alt, and Water pump. 4 Pin. Plug #2. Branched off with the 2 ignitor plugs, (White Plug is what i want know know) 2 pin. Wires: Brown, and...

Fogs looks great man, thanks again. i didnt see any where but what were u plans for paint?