Search results

  1. B

    7mgte AFM issues, please help!

    ok i will look around for one. Where i live i am at 3500ft. Their is a air/fuel gauge hooked up and its reading right in the stoich range so i think my mixture is pretty good. I also forgot to mention that i replaced all the spark plugs while doing this tune up. I got bosch plugs from napa...
  2. B

    New member w/ 7mgte swapped 4runner

    thanks! yeah it has minimal rust. there is some around the rear fenders, but i will be trimming it out. I dont like how tall the rig is, so i will actually be lowering it about two inches. Then i wil have to trim the fenders a bit to clear the 37s
  3. B

    7mgte AFM issues, please help!

    yeah i saw that 32 is for the HAC sensor. I'm assuming it probly always has that code stored because i dont think they hooked that up, but i can look around on the rig to see if i can find it. what exactly would it look like? also will the engine run ok without it? I do know that i have a pre...
  4. B

    New member w/ 7mgte swapped 4runner

    thanks guys! here are a couple pics
  5. B

    7mgte AFM issues, please help!

    yeah i had the batt unhooked for a while and i also pulled the ecu fuse. after i put the ecu fuse back in and turned the key to the "on" position it only came up with code 32. I did not start it again after that. i will mess with it more tomorrow. i am going to leave the batt disconnected and...
  6. B

    7mgte AFM issues, please help!

    hey i just joined recently to buy a used AFM for my 7mgte. I have a 1987 4runner with a 7mgte swap. I got the vehicle with the swap already complete. It has been running kind of rough since i got it and it seems to have some slight fuel cut issues during steady-low boost. I started looking into...
  7. B

    New member w/ 7mgte swapped 4runner

    Hey guys i joined the site a few days ago to find a used AFM for my 7mgte. I live in Summerset SD. i have an 87 4runner with a 7mgte swap. Its an off road/ rock crawling rig. I dont actually own a supra, but i wanted to join anyways because i know i can gain lots of knowledge about the engine...