Search results

I got new o-rings for the heater core but should I replace the clips that hold the pipe to the core pipe?

I got the heater core out (PITA)!!! I assume I should go with OEM heater core, right? As I am going to have to wait for about a week for parts, (i get a good discount from dealer in NM) is there a writeup somewhere on installation tips for installing the core and dash? I think I will forget...

I had no oil leaks when I got my Supra 6000 mi ago. I switched to RotellaT syn 5w40 and now have a leak at the front arch of the oil pan. The rear of the pan under the rear main is starting to leak. I had several seeps and a flowing arch leak on my Land Cruiser before I changed to RotellaT...

I have a occasional smell of coolant in the car. I assume its from the heater core or a hose to it. There is no coolant on the floor and the coolant loss is just a several onces for over a month. I see there is a hose under the hood that has or is seeping as there is red coolant crusted on the...

Will this TRD LSD http://www.cabeperformance.com/detail.asp?SKU=00646-41301-100 work in my n/a auto non LSD? Fits Tundra,Sequoia,T100,Tacoma V6,Srunner and Prerunner, I know Supra is not on the list but the price is right if I could make it right?

I found out my Supra doesn't have LSD. I did a search with no luck. Is there a way to add a Toyota or after market LSD to the diff without taking it apart/rebuilding it? In 4x4 trucks, they make several diff lockers that you just install in the diff with little work...

I think I need new tires but don't know if I need snows. I drive 70 mi one way from Grand Junction, CO to Rifle, CO to work. It could be raining in GJ but will be snowing in Rifle so I will have to drive in a mix of both. I have a Land Cruiser for when I know its going to snow. This is why I...

There is a delay when I set the cruise. When I set it, the cruise delay is about 5mph at 80mph but it does catch up. Is this normal? I checked the cable and there is no slack. The linkage is pulled back to the stopper by the spring. Should it be resting on the stopper? Where else do I...

I replaced the valve cover gaskets and the middle gasket doesn't look to seal very well. When I was calling dealers that had Supra's for sale more than once told me that the car runs good but has a miss fire after they wash the engine. I was thinking of putting some silicone along the...

New OEM lift gate shocks are over $100 each. Is it possible to have them rebuilt?

Is there a reason not drive without it? What does it do other than to keep the motor clean and dry?

My Toyota rebuilt rack I just installed seams to turn harder to the right than the left when moving. Is this normal, is there a break in period? I flushed the pump before hooking up the rack.

I need to replace the large hose from the valve cover (by the fill cap) that goes under the alt to the block. Can I make a hose? What size is it? Same with the valve cover (looks like a PCV without the valve) breather hoses (one on each valve cover) what size?

I did a search and found a link to how to do the valve stem seals without removing the head but the like is no good. I have the valve cover off and am going to change the timing belt. How much more work is it to replace the stems?

I have a new air intake hose for the cracked hose that goes to the throttle body on order from Toyota. I sealed the crack as good as I can with some sealant, can I drive it until the part comes or do I need to park it?

Is there a way to remove the timing belt cover without removing the rad hose and fan belt?

I put in a rebuilt dist and something was wrong, it spit and sputtered then died. I removed it and tried it again and it ran rough. Now I need to know if I when you set top dead center on compression for #1 cylinder per the factory service manual, can it be 180 deg off? The method I did...

Did Toyota sell '87 turbo Supra? When I go to web sites, they usually ask if its a turbo or n/a when I get to the motor selection. I called Toyota dealer about my rack for the steering and he said there is no turbo in 87, is he correct?

I took the rack off as the pass side boot was leaking. The driver side boot was full of oil too. It doesn't look like there is a seal for the driver side. Should the driver side boot be full of oil? Should there be oil in the pass side? Is the pass side the only side with a seal on the rack? If...

My right rack seal is leaking at the boot. Is there a way to replace the seal or is it a pain in the a$$? Looks like I would need some SST's. My search shows most just replace with rebuilt one. If rebuilt one, what brand...