Search results

Bought this I/C kit off E-bay a year ago. I was silly and naive, and a bit to free with Mr. Visa. Anywho, neither the I/C nor the BOV have any markings and I was wondering if you wise folk may know what I've got here. .

Some things I gotta just learn the hard way I guess. I didn't break this bolt loose before pulling the Head/Tranny/Engine out. How can I break the bolt free? I've tried a strap wrench around the pulley and only succeeded in popping myself in the hairy gumdrops. :aigo: I don't have an impact gun...

While I've got the heart pulled out I figured I should see what I can afford to upgrade. 1. Looking to upgrade my CT26. Who can I send it to that'll take care of me without breaking the bank? 2. since the tranny's off figured i should replace the clutch. Where can I find an aftermarket one...

Does anybody know anything about the Nippon Racing Pistons available on E-bay? I want to bid on -em, can't find info on them, haven't heard anyting about them.

In the process of rebuilding my pig I'll be eliminating the EGR with blockoff plates, removing the charcoal canister (got a JDM thermostat housing to clean that up). Was wondering: -Will removing the EGR screw with the ECU at all? -Gotta drill the gas cap right? -Does the EGR cooler affect...

I'd like to replace as many lines as possible during my rebuild, and was wondering where I can find braided SS lines and fittings for items like- -Turbo coolant -Turbo oil -oilcooler -Fuel (coming in/going out) -anything else ........how many other hoses can be replaced with silly-cone...

Since the valve in cyl #5 popped and the piston got a beating worse than Tyson in his last fight, I've got to replace it. -What is the most cost effective way to swap out a piston? -Must all hardware and bearings be replaced? -can the oil pump be tested? -what pistons should I...

Getting ready to pull my head for reasons I've mentioned in other posts. Problem: Getting cam sprocket notches to point straight up. Using the starter(perhaps not the best way) the notch rocks 180 from 2 o'clock to about 8 o'clock. Same with using a breaker bar. So the question of the...

Can the head be fixed if a plug hole gets stripped out?

Hello all! Name's Eric, Bought an '89 turbo targa a year ago and my life will never be the same again. I recently received from on high the dreaded BHG on the engine that I had swapped in after spinning a bearing. So now I'm ripping this pig apart finding more gack than a peepshows floor...