I have been looking all over for the net for a complete bolt guide. I finally decided to bring it here. I am looking for a guide that has the bolt length, the size of the bolt head, and where it is located on the engine. Does anybody have a list similar to that? Thanks.
Casey
factory hardware was used to replace parts. I have ARP rod bolts and ARP main studs. Is it possible to replace the factory bolts with the new ARP bolts that I have without changing out the new bearings there were put in?
If using 80% duty cycle is recommended maximum, what would be the lowed duty cycle you could have? I want to reach between 600 and 700 hp so using 1000cc injectors seem to be right (using 80% maxmium duty cycle as a ceiling) but is there a point where the injector is too big to allow the engine...
I seen a very interesting performance part on a 7mgte. It was two oversized (I think HKS) injectors that fed into the intake system right before the throttle body. If anyone can get me some information on it would be appreciated.
it's blow by. if you install an oil catch can it would decrease the amount of oil that you find when you take off the piping. if you read a toyota service manual it will tell you that its not uncommon to see a residue. by residue I mean that when you take the accordian hose off, you will...
I am in need of a carfax for a car that I am looking for...
1N4AL11D65N927992 this is the vin number. It is a 2005 nissan altima, manual transmission. Any help would be great.
Whasian
welcome to supramania. We are better over here... vs s.f. (I think) What part of texas are you in. I am in houston. Wether you decided to go J series or keep the 7m (I prefer the 7m), you chose a good car.
Whasian
I feel that both cars are in seperate classes. I love both cars more an anything. I will always have one (and have left women becuase of this car). I own an mk3 (ma70) but will buy a jza80 after college. Both of these cars show excatly what toyota was about when it came to a sports car (too...
Anyone that posted in this thread saying anything bad should really take a second look. I was totally able to talk to Jonathan when I needed to. I had complete communication and my parts were being shipped. He is working hard and making a living, why would anybody on this forums talk trash...
Do you think I could get a spec sheet for that engine? I am curious to find out what the internals are, how the block was build, as well as the head and all of it's internals.
Whasian
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.