Recent content by REG8000

could use some help on this 1990 7mgte wiring on the thermostat housing on the harness i have two spade clips and only one in the housing. i have one wire Blue ans white with the end missing plug in for the cps and one to the oil sender i know there is a cold start sender but i have two wires...

1990 supra turbo flex plate there is a spacer about a 1/8 thick,, dose it go before or after the flex plate to the crank shaft i forgot after 3 years help thanks pm me if you can help

HI I'm a 69 year old car nut . i restore mark3's as a hoby kind of spendy but fun . it has been 11 years now and winding down . i do all of the work myself but have the machine work done for me, i hope i can be of service rod

hi if you are unsure about it do it right. take it to a good!! shop and have it turned . they pull the plugs on the rod jurnals and clean the crank. i have seen them pluged along with the filter scren on the oil pump when not useing a gasket. they will be glad to check the rod, if its bent i...

hi i have rebuilt 13 7m's and if needed i have had the top of the pistons milled the same amount that was tacken off the block . i have not had to go more then .015 and run into no problems. i rebalanced the pistons but they were in limets and used a hks i.2mm gasket, been running for 3 years...