Recent content by Nougie

Set up- BPU 7mgte Issues- Boost will not hold or exceed 5psi Possible Culprits- Wastegate/boost leak, ? The Cool Story- Installed the new DM IC Kit. -day one held boost just fine(10psi with Hallman MBC) -day two, i ate a driveway(my car is pretty low) and broke the lower ic pipe t-bolt...

Patience and knowing where to look is key. There are many nice,clean, and even orginal ones all around. I am the second owner of mine and drove 12 hours for her. I wanna say, it was well worth it. You have to know what your looking for to find it.

close thread. Culprit was a leak within the vaccum lines. thanks!

well quite honestly after the 2 full turns i didnt see any change so i just decided to call it a day and stop disturbing my neighborhood with mutiple pulls of a loudass supra lol. By any chance do you believe that that may just be my problem? im sure two full turns should have been enough for at...

Picked up a Hallman mbc locally and installed it. Easy as i thought. I now have a few Q's reguarding the mbc. Currently its getting its boost source from the CT26 Housing Nipple/line and of course back into the wastegate actuator. I did multiple test runs only seeing 6psi with adjustments going...

I had a very similar issue as i thought mine was fuel/spark related. Turns out, it was a leaky/leaking BOV. Mostly "missed" in higher RPMs in 3rd!

Dont boost leaks also cause this? Both my supras have done this.

Whatever you do, get one! Went from being 2 cars lengths behind my brothers stock 91 Mr2-T to 2-3 car lengths in front of him with an open Recirculated-DDP!:) and yes, I was stock too. Oh and then a couple buses in front of my co-workers miata lol.

Yo mamma so bald i can see wat shes thinking!!!

232bhp....Get it? lol jk tho. Im sure a composite can hold up to about ~300-380hp good enough but as they said, if youre gunna pull the motor, u might as well just go MHG for cheap insurance and peace of mind:)

I failed recently also. The culprit can be anything. I mean that literally. For me, all it was, was the vacuum/hose from the charcoal canister to the firewall/tank? That hose was hard and brittle as a focker! TIPS - run the car at minimal 15 mins prior to test -adding LUCAS/Chevron techron...

Im just about to past the ~500 mile mark on my BHG fix. I went with an hks 1.2 mhg and arp headstuds. I only decked the head and measured the block with a straight edge. The block checked out good so i didnt deck it. So far so good. Ittl take awhile for all the coolant/stream in ur cat/system to...

If u really want coilovers and ur on a budget, id say ur best bet would be the megan ones. Ive heard really good reviews about them all around. And besides, thats probably the cheapest ones youll find for brand new. Just dnt get godspeeds. A local member got em and they pretty much took a shit...

It depends on how your car is going to be driven. Is it a daily driver? Track car? Etc.... From what ive seen, the lowest youll be paying for a new set of coilovers would be around $700-800 shipped to your door. A used set may run you around ~$450-600 depending on the quality/brand. If its just...

Thanks for the feedback guys! My car is running percfectly fine! I just figured having the car cool is better then hot, but then again the feedback u guys give me is great and makes sense. Im not too serious about it so ill just throw in a new thermostat! Thanks guys!