Recent content by myfst89turbo

covered the stock dash and mounted my racepak iq3 dash

I need to know if the rear speed sensor reads drive shaft speed & i'm 90% sure it is a hull type sensor just need to verify it is. the trans is out of a 89 turbo abs car.

hung the water/meth pump & tapped the windshield reservoir still need to wire in the controller

i had it done by the guy who painted the car

thanks guys for the love i would say just under 20k. but i wouldn't be surprized if its over that lol

thanks, it gives it a much cleaner look imo

installed 1000 cc injectors -8 split to -6 & -6 return stripping the front since im running a greedy replica i decided to run the power steering cooler & the oil cooler in the openings of the bumper It fits lol then went back to the rear of the car & installed two 255...

then this showed up and changed everything thing up pulled it down to install valve stem seals & bc springs & retainers with bc 264 cams then i decided to kick it up a notch and decided to have the bottom fully build 10:1 ceramic coated tops and coated skirts

decided to upgrade the suspension dropped the rear subframe & found this :( broken weld stripped her down welded every seem and fixed the cracks started to put the rear back together shot of the extended arp studs rear installed

after a couple years without a supra, I decided to buy my friends 89 turbo and get back in the car scene. it was a pretty clean car but it needed paint and it had a build 7m motor in it. my intentions were to just paint it and essentially make it a bpu car. but that all changed i got a great...

what's up with my catch can? still haven't received it. it has been a few weeks since you said it was done. i will give you a day to answer before i give you a bad trader rating.

thanks for the input. as soon as i get the harness im going to send it over to tweak and def gonna pick up the aem v2 from driftmotion

Ok so I just picked up a 95 USDM 2jz with a 6spd harness. My car is a 89 (gray plug)turbo 5spd. I want to run the aem EMS, but not sure how to get there. Do I order the 2jz to mk3 harness from tweak & run the 7m pnp or do I use my 95 harness & use the 2jz pnp aem EMS or maybe I just have this...

installed my afpr and Mishimoto reservoir the mount is temp till i move the battery to the back

I have a build bottom end with a low ra, back when i had it build about 2k miles ago. but long story short sold the block but i have it back now and it has an oem head gasket on it. i now have a new head that is ported and all that other good stuff should i have the block re decked again or a...