Recent content by johnverheij

yes you are right i bought one from a 2j and only the aluminium part is different thnx

hi guys will this work on a 1jzgte? 2JZ Timing Belt Idler Pulley thnx

thanks this is making me sleep a lot better

i am using the zeitronix zt-2 and egt sensor and the apexi afcII the sensor is placed in the turbo near the T3 flange

hi guys i am driving a mk3 with a 1jz garrett gt35r and needed mods but my egt`s are going as high as 880 celsuis i don`t think that is save my af ratio is below 11 what can be wrong?

hi guys, i have a 1jz with sard 540cc and a gt35r and aeromotive fpr i`m trying to tune it at the moment i found out it is running very rich so how much fuel is safe to pull with the afc? and what are the settings for low throttle and hi trottle? with that i mean you can preset low throttle...

did anyone bought something from this shop? http://projectptp.com/ i want to know if it is no fraud thnx John

here's the movie i made with my telephone http://nl.youtube.com/watch?v=Qo2GDgv31sw

my mods are: 1jzgte stock twins set on 1.1bar 3"fmic + piping 3"exhaust with cat removed hks bov apexi boost controller apexi fuel comp. jun light flywheel

hi guys, today was the day for the dyno i took my 1jz for a test and i liked what i saw stil driving it with the stockers this is the sheet not bad i think

winter project dus nog ff niet

Thnx for your replies guys

so just keep the power down

he guys i recently bought a clutch from driftmotion a break in of 500 miles in required my question is how do you break in a clutch properly

yeah keep us up i need to replace my clutch also and want to keep the engine in good luck