Recent content by driver005s

Reserve for updates

Reserve for pictures

I bought this car back in September 2009. It was originally a black targa turbo auto with 130K miles. The car was completely stock with a bad 7M. I swapped in a 1JZ with an R154 a few months later. After three years I finally got the car completed. Current Picture Mods...

Thanks!

Ebay $229

Not sure if this was posted before but how about some Jza70 R floor mats.

Hey guys I'm looking for a 1jz proefi base map that I can use to get my engine running after I complete my wiring. Thanks in advance My email is jadbir@yahoo.com

I think the said 700hp

All that beating that your buddy did to the motor Friday night is what lead to it blowing. Anyway if you do a 2jzgte it will cost you around 3-4k A 1j will be 2-3k Doing the 2jz you will be more happen rather than fixing the 7m.

Yesterday I drove the car for the first time after the swap. The tranny shift up fine without problem but when gearing down it won't go in to gear. I bleeded the line 3 time. No matter what gear you try to go in it won't go back into gear unless you yank it.

My buddy is having trouble with his temp gauge after his 1jz swap from jzx90. He said that after 3 min the guage will go from cold to full hot within 20 sec but the engine is not over heating. He replace the sensor but the same thing happen. He disconnect the sensor and the gauge didn't read...

Hey guys I want to put some Work xd9 18x9 +20 in front and 18x10 +18 I'm using tein flex Will this be flush? will it require roll or stretch tire? Also what tire size would you recommed?

Had my car idling for about 40 min on thursdays, then yesterday I stated it up and the hydro fan blade won't spin ( not even by hand). How can I fix it? What cause it to go bad? Btw when I first got it I spin it by hand and after a couple revolution it would get stuck then I woukd have to...

Hey I give you a call but no answer If you have fuel spark and air it should start. The ignitor can't be bad cause your getting spark. It could be compression or timing. Btw how did you verify that your getting fuel? Is your spark plug tip have haas on it? The car did your 1j came out from?

She runs with no issue now. The plate wasn't install properly so after 10 minutes of running it came loose and probaly was not spinning. Thanks for the help guys.