Recent content by A-to-the-J

  1. A-to-the-J

    My '90 3E5 Turbo Targa :)

    Keep it going! Damn I miss my Supra so much.
  2. A-to-the-J

    What did you do to your supra today? Pics

    Pics or it never happened [emoji6] Sent from my iPhone using Tapatalk
  3. A-to-the-J

    What did you do to your supra today? Pics

    As soon as they're properly mounted, I'll be happy to share. But to give you a hint, go to your local junk yard with measuring tape. I'll post up all progress pics and everything. Hopefully this weekend. Sent from my iPhone using Tapatalk
  4. A-to-the-J

    Wheel Fitment & Question Thread

    I've ran 18x9.5 +22 with 275/35 all around. Dunlop Direzza DZ101 with just a fender roll with zero issues. The max out I went up front was 18x9.5 +12 with 255/35, and it rubbed then. That's max out you can go with a rolled front fender. Sent from my iPhone using Tapatalk
  5. A-to-the-J

    What did you do to your supra today? Pics

    I found fog lights that fit with the Gracer Bumper! More pictures when I properly mount them with brackets. But here's a teaser: Sent from my iPhone using Tapatalk
  6. A-to-the-J

    Wheel Fitment & Question Thread

    With those sizes, I'd go with 18x9.5 +23 with 255/35. I prefer a square setup if you're going to be going through corners. IMHO, it's more predictable. And it should be flush without any rubbing issues. Sent from my iPhone using Tapatalk
  7. A-to-the-J

    Wheel Fitment & Question Thread

    Use this website to help out..it helped me with all my wheel purchases https://www.rimsntires.com/specspro.jsp You'll have to put in stock specs which IIRC is 225/50-16x7 +37. Looks like with a 255, it will be 1.6" closer to suspension and be a little sunk in from the fender. And that would...
  8. A-to-the-J

    What did you do to your supra today? Pics

    Thanks! 18x9.5 +22 square. With 275/35 RE71R. Tread width on the tires are a little too wide. Going for same size but smaller tread width. Sent from my iPhone using Tapatalk
  9. A-to-the-J

    Where the heck can I find centercaps for RacingHart CR's!?

    Try calling VR Wheels Sent from my iPhone using Tapatalk
  10. A-to-the-J

    Wheel Fitment & Question Thread

    Not sure if it's been discussed, but for those looking into tires, check the section width and tread width, it will blow your mind. I'm currently running 275/35 on 18x9.5 +22. I've ran that size before, but the RE71R tires have a wide tread width and rubs a lot. I still run them though lol...
  11. A-to-the-J

    What did you do to your supra today? Pics

    I installed the best wipers ever! Silblade. Oh, I'm also back to reclaim my Panda trademark for now It may not be as nice as Ken's car, but it's something. Sent from my iPhone using Tapatalk
  12. A-to-the-J

    Headlights and speaker issues

    I know about manually putting them down but I'm don't want to do it every time I drive at night. I'll check the driver side harness in the fender. However, the speakers are still a problem. Nothing is grounding out. I tested them on my friends car to be sure they're still good. Sent from my...
  13. A-to-the-J

    Headlights and speaker issues

    Hey guys, I've searched and couldn't really find anyone with the same problem. Today when I went to work, headlights opened and closed normally. After getting off, I noticed my headlights were open. I turned on the lights and tried to close them and they just closed and opened a number of times...
  14. A-to-the-J

    Anyone have experience with an Iron Sintered clutch disc?

    The friction plate and teeth are steel, the main body is aluminum. Sent from my iPhone using Tapatalk
  15. A-to-the-J

    What did you do to your supra today? Pics

    Riley....Can you take some pictures of the sides of the mirrors? I think mine are different. Mine have a little extension that follows the trim, you can see it on a few of the rear quarter shots. The lights are all LED plasma chip bulbs. I think they're nice on the car...and pretty cheap too...
See more
Top Bottom