Does anyone have a recommendation for a good machine shop in the Springfield MA/Northern CT area? I'm just looking for a place to do the head and block work that comes with a blown head gasket. I went to a place in Westfield, MA years ago (forgot the name), but I want to check and see who else...
i was just wonderin if anyone in mass had a BIC ddp. i was thinking of getting one but i dont kno if it will pass the mass state inspection and i dont want to spend 500 bucks if it wont pass.
thanks
i got the bolts on the front drivers side off pretty easily. i drenched it in liquid wrench and had to have my dad do it since im way to weak. the bolts and the nuts nove freely and good as new. the passengers side was a little harder. i got the nuts off but the bolts wont move. i couldnt do it...
i actually havent done it yet, i was gonna start but school stuff got in the way. im gonna try tonight, start with just liquid wrench and then try the more fun freezing and stuff.
thanks
yea, its too bad im fresh out of liquid nitrogen. can i get that CRC freeze-off at an automotive store or hardware store? i think itd b worth a shot.
is there a difference in the way the camber bolts are compared to the caster ones? and which ones are the camber bolts on the front; the one...
i just found that their are 8 so i think im just gonna leave it. it aint that bad anyways.
thanks for all the help, especially that link, had good info in it
thanks again.
a couple weeks ago i got the tokico/eibach suspension on my car which lowered it a bit. i went for an alignment and the guy said that he couldnt even budge the camber bolts and that i needed to get new ones in order to fix the camber. i went to toyota and got 4 bolts; i thought one for each...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.