Recent content by 69ho

No ABS

O.K. I'll check that out. Where is it located?

It was advertised as being a 7M-GE harness, but I don't know. The connector on my harness looks exactly like the one I am referencing in this photo; gray, 4-pin with three wires populated. I thought that the knock sensor was a single wire connector?

This is not my harness, just a picture of one that I found onlline. I am able to click on the photo and then able to zoom in. As I stated above, I don't think that it was connected when I disassembled.

Can anyone tell me where the 4-pin gray connector in the photo to the right of the person's foot goes? It only has 3 wires populated and I think they are yellow, red and black. I am doing a head gasket replacement and when I disassembled, this connector was going nowhere

Can anyone tell me how the cover his located on the block? Dowel pins?

Did you remove it and have it machined correcting the non-parallelism with the block deck as well?

This engine had been rebuilt by the previous owner and I was concerned that the cover was installed minus a dowel or locating device of some sort causing it to be positioned above the deck. I have not been able to find a good illustration that shows me what locates the cover. With the cover...

The block has not been machined.

I am replacing the head gasket on my '89 Supra and noticed on re-assembly that the top surface of the rear timing cover is above the block deck surface from around the middle of the cover over to the left side and at or below the surface going the other way. Is this normal? Where should the...