I need suggestions on how to start an engine after it has been sitting for a couple of years. So far I've drained the coolant and shot some WD 40 in the cylinders. I'm planning to dump a little Marvel mystery oil and Lucus oil product over the cams and in the cylinders. Then I need to hand turn the engine. I'm going to drain the fuel and add Gas treatment and Hi octane fuel. Also, I'll add new oil and filter along with motor flush and after it runs awhile, change the oil and filter with new.
Is there a way to spin the oil pump with an drill motor before starting it?
Please give your thoughts or suggestions.....thanks!!
Is there a way to spin the oil pump with an drill motor before starting it?
Please give your thoughts or suggestions.....thanks!!