I just installed the Maft Pro w/speed dens. & used the "Quick Setup 4.40" sheet for initial settings. Wired as instructed & everything is connected but not soldered yet. I have the Map sens on the driver side fender w/vacuum line connected to the port above the FPR Vac. line. The AIT is just before the TB on 3K pipe. I'm having the following problems. Engine idels erraticly. 500-1000 RPM a few minutes then dies. Start it up dies, start it up give gas idels erraticly again. If I rev it slightly past 1100 rpm it dies. Its also running real rich. I have searched & read through all I could find but nothing on this. Could have missed it but it took me about 5 hrs to install the pro & I have spent another 8 hrs looking for the cause of the problems so I'm kinda spent & would like some ideas on what to look for.
Thanks
Thanks