Search results

Has anyone tried these ebay cheapos? Do they work??? Im looking into ways to get rid of chasis flex in my targa. Are they worth it or is there other alternatives for better options? And yes I have been using the search engine with little luck. Thanks for any advice you can provide...

Ok guys. I have been attempting the tookwick 2jzge coil upgrade. found some used coils and wires. Purchased a new coil harness but chose to lengthen the original as a practice run before hacking up the brand new one. Got everything installed and it ran like crap. Didnt even take it for a ride...

First of all I have changed nothing to the car. Last weekend all of a sudden the AFR on my LC1 are jumping around more than usual. And going more into the lean area. Normal previously was jumping between mid 14"s to low 15's at idle. Same at cruising speeds. Now all of a sudden they are...

Okk pro's here it is. My brakes have been fine up until a couple months back when I changed to braided brakes lines. Also changed rotors and pads. Ever since I have done this, my brake pressure is normal when stopping. But when I sit stopped I and hold pressure like normal, all of sudden...

And b4 you ask yes I have searched. I know now after starting my port and polish project that its not recommended to port match the exhaust side cause of the revision damn and all. My question is this. How much of a revision damn is needed to be effective. Reason I ask is that like I...

Does anyone know for sure what aftermarket manufacturer makes Viton seals? I have searched for the answer and have not come up with anything except IJ stating that oem toyota's are. They are very pricey and was wondering if anyone knows of an alternative. I bought a ebay kit and emailed the...

I bought a new water pump from autozone yesterday. I did this versus a toyota one for two reasons. Obviously the biggest is cost, but also cause its more convenient. I notices when I got home the the prop that moves the water are quite different on the two. Does anyone know if this will make...

I have learned alot on this forum and im relying on you pros to teach me some more. I bought a used oil cooler (first mistake) and when I recieved it, it appeared to have water inside. The previous owner confirmed that he flushed it with water. :3d_frown: I need some advice on how to get all...

Well like it said gents. Im into the process of building my first motor. Let me start by thanking everyone in advance on this forum. You guys rock! Without all this knowledge I would have never attempted this. These pics are self explanatory. I pulled the motor over a month ago, so this...

does anyone have any experiece with this oil pump? Just wondering if it indeed flows more volume then an oem? Going through a rebuild right now and am looking to replace mine. Thanks http://www.importperformanceparts.net/

I have researched for over an hour now and still havent found the info im looking for, so I apologize in advance, if im starting a new thread when one already exists with this info. Question is, to remove the rear knock sensor is it necessary to remove the starter? I have and 89 turbo with a...

Well I tried a search and came up with nothing so If im duplicating a thread then I apologize in advance. Im having front end suspension noise and Im not for positive what it is. It happens when your are turning right or left but is louder when you turn right or put the weight of the car on...

Ok you guys are obviously pretty knowlegeable and I have yet to hear a definite answer to this question. I am planning a turbo upgrade to my NA and I need to know if the NA block is identical to the turbo. My NA only has 58000 miles and of course I would rather use my block then go with...

Can anyone please guide me on how to tighten the crankshaft pulley to the recommended 195 lb ft of torque without the crank turning on you? Any help would be appreciated