Hey guys ive recently had an issue with cooling my engine down. It runs hot and randomly wants to over heat but then I shut it down let it sit for like 3 minutes and fire ut back up and it starts working fine? I do have a coolant leak on the turbo and on the radiator unfortunately. Not sure if...
Wassup guys i have found a solstice transmission. Ive read that its almost identical to the r154. That being said ive been reading that the input shaft on the ar5 is longer and has different splines, what if you replace the input shaft with the one the r154 has and put a 7m bellhousing? would...
Alright guys I've been doubting my transmission, im rebuilding my engine but I have an auto tranny and im expecting to make 300-450 hp. Im not sure if the transmission will hold up or what would happen?
Alright guys im having trouble figuring out how to PROPERLY install a metal head gasket. I know you just clean the block surface machine the head and block I have that done and out of my way but I already installed the rear timing cover that goes on the front of the engine. Do I put a little bit...
i found s bearing set but i dont know if these are the same material.
http://www.ebay.com/itm/Piston-Rings-Set-Mazda-626-MX6-2-0L-DOHC-16-Valves-FS-/250743961803?hash=item3a618138cb:m:mq8Zu4XXVWVzcSJxPkt4JRg&vxp=mtr
Alright guys I found a piston with a different piston ring and its bothering me, I want to change all the piston rings now, what are some good piston rings?
Thanks guys! People i know swap their 7m for a 2jz And i decided to keep mine. so itll last as a daily, im aiming at 450hp with 550rc injectors. And the forged pistons have shorter side skirts than oem cast ones.
Hey guys ive been reading that forged pistons arent good for a daily, what do you think?
I have the following
-probe forged pistons
-stock rods
-king bearings
-brand new oil pump with steel braided hoses
-machined/honed
would the forged pistons wear out fast or whats the deal? :1zhelp:
Thanks! I couldn't find 2 30 mm freeze plugs, I read that the older 7m had hex screw caps and the one I have doesnt, where do I get those from toyota, also I went to napa and we had a discussion that brass freeze plugs are better than toyota oem freeze plugs, I thought toyota freeze plugs were...
Im having trouble on deciding on what type of freeze plugs specs etc.. on my 7mgte block, i cant find the front dome freeze plug on the autoparts anywhere, would a regular freeze plug work or it has to be a dome disk type?
I think im going to order that too, also whats up with this one?http://www.amazon.com/gp/aw/d/B007P73WQK/ref=mp_s_a_1_fkmr0_1?qid=1438651841&sr=8-1-fkmr0&pi=AC_SX110_SY165_QL70&keywords=ishino+gasket+7mgte
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.