Recent content by Tura_1JZ

Sup everyone, I recently installed a catch can and now the car is bogging at 3200 RPM. I use the PCV port and the exhaust cam cover port for the catch can. I installed a breather on the iacv, car is a T70 at 20 psi with afc neo. Never did it before the catch can install.

Bump

I got a question, I just had my car dynoed on a AFC NEO but forgot to set the TPS setting on the NEO. I just noticed full throttle is 75% on the NEO ( recently installed a TPS sensor calibrated),my question is if I set the TPS setting on the NEO now do I have to retune the car again ?

Looks incredible, but that radiator has to go.

Sorry to confuse, its a product of the lean/rich spot. On the data log injector duty cycles are at 0% at 5812k then it goes full rich all the way at %100 duty ugh. If it were ignition situation the injector duty cycles wouldnt be affected or Im guessing. Spark plugs are at .24

Bump

Still doing same thing , but the 1st time I gunned it in 1st it was clear with no breakups and in 2nd also. The next time I hit it again it started breaking at 5812K. This is driving me crazy need help!

16psi 440 2jz injectors Walbro 400 Driftmotion damper bypass Aeromtive fuel reg. NGK IFR6I11 plugs Greddy Thrust intercooler Tila 50 mm Blow-off 6- puck clutch Fuel pump resistor bypass The turbo has a T3 63. backhousing too small. It was 342hp and 306 tq on dynojet. I know about the wire...

I have a auto 1jz converted to manual but still running the auto ECU. I dyno tuned the car about a 2 months ago, but I recently been getting a Lean to rich spot around 5800-6000 rpm. Now my tuner said it's the Auto Ecu shift limiter ,on the Data logger you can see the injector duty cycle go lean...

excellent advice, Thanks !

bump

How long was the car down? It might be bad gas, if not check cam and crank sensors.

I have a stock 1jz auto ecu tuned on greddy emanage ultimate. My auto ecu went bad and I want to know if I use a Manual ecu do I have to retune?

48psi fuel,I made 325whp on a t70(truck turbo) .63 exhaust housing ( too small I know ) but the car was running really rich and my tuner had to take off alot of fuel. I found out Aeromotove FPR is faulty some I ordered the DM one. I'm going to re-tune at a lower fuel pressure and up the boost to...

Bump