Recent content by ronnie4

On the camry it'll be the cable that goes to the pedal to the black box in the front of the engine bay, 4cyl and 6cyl are the same.

What motor mounts are you using?

So tie the brown wire coming out of the back of the cluster to a ground?

Well I tried reversing the white wires, didn't do anything. I also tried messing with that other alternator wire, didn't do anything as well. I cleaned all the grounds around the battery, are there any other grounds that would affect the alternator that I should check?

Well I've replaced both the alternator and battery on my 1JZ and am still having the same issue. When I first start it up it will read 14.5v across the battery. After driving for 5 min it will only read 12v and die if i let off the gas. Can anyone verify my fuse box/alternator to EB1 and...

Yeah it's pouring out from the plate on the exhaust side of the block that says "7m" on it. I'll pick up a gasket for it today.

Yep I know, I put some it it right after that. It had just drained a quart onto my garage floor after idling for a few mins.

That's what happens when you have a massive oil leak on the side of the block. Thanks for the help, I'll replace the pump and see what happens, hopefully that's the issue and it's not a clogged block. Anyone got any ideas on how to check water flow through the block? I was thinking of using...

Well I got the pump out and it seemed to looked ok, the bearing was making a squealing sound though. Is this a factory water pump? Does anyone think my oil looks milky?

Well, my 7m is overheating. I checked he thermostat, it seems fine. The radiator doesn't seem clogged, I can pour water through the top and it will immediately drain out of the bottom if left unplugged. I took the top radiator hose off while the engine was running, other that the...

Anyone know what the resistance spec should be? I looked on the cygnusx1 site and couldn't find it.

TPS, guess I should proofread before I post, would a bad TPS cause the engine to die after a few seconds though? It idles fine when it'll run.

I start up my 7m and itll run fine for about 15 seconds, It'll idle just fine and I'm able to rev it up with no problems. However it'll just dis after about 15 seconds of running. I'm getting a cod3 41 and 51. I'm guessing 51 is becaust I don't have A/C. I tried running it with the YPS...

haha, so true

Did you guys just ground it to a metal piece near the cluster or tie it into the ground on the engine harness?