Engine dies after running for 15 seconds

[ronnie4]

I start up my 7m and itll run fine for about 15 seconds, It'll idle just fine and I'm able to rev it up with no problems. However it'll just dis after about 15 seconds of running.

I'm getting a cod3 41 and 51. I'm guessing 51 is becaust I don't have A/C. I tried running it with the YPS pulgged in and unplugged and still get the same result. Anyone got any ideas?

 

[AJ'S 88NA]

I start up my 7m and itll run fine for about 15 seconds, It'll idle just fine and I'm able to rev it up with no problems. However it'll just dis after about 15 seconds of running.

I'm getting a cod3 41 and 51. I'm guessing 51 is becaust I don't have A/C. I tried running it with the YPS pulgged in and unplugged and still get the same result. Anyone got any ideas?

Codes???What is YPS :sarcasm:

Your TPS needs adjusted or it's bad, or bad connection.

 

[ronnie4]

Codes???What is YPS :sarcasm:

Your TPS needs adjusted or it's bad, or bad connection.

TPS, guess I should proofread before I post, would a bad TPS cause the engine to die after a few seconds though? It idles fine when it'll run.

 

[AJ'S 88NA]

TPS, guess I should proofread before I post, would a bad TPS cause the engine to die after a few seconds though? It idles fine when it'll run.

Well that's what codes 41 and 51 are pointing at, all you need is a ohm meter to set it according to the TSRM. I'd say check it, set it, then you would know.

 

[ronnie4]

Anyone know what the resistance spec should be? I looked on the cygnusx1 site and couldn't find it.

 

[jetjock]

http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=101