Recent content by FullNelson

Yes, my stock one just ruptured today. Im entertaining the possibility of upgrading to an aluminium one now, but only at a reasonable price, if not a nice OEM one will be fine. I might be PMing you Emerica if I decide to go that way. Thanks for the offer. The cxracing one looks nice, were there...

Has anyone purchased the OEM replacement and regreted not going to an aluminium unit? Are those OEM still all steel units and if so what brands are recomended? It looks like the Mishimoto is the best bang for the buck aluminum radiator, as Im not going to spend $400+ on a radiator, Are there...

No, it is not new, it was purchased second hand and I have been over it before with a clean and lube along with a fluff and buff to the feed ramp. Not comparing the hi-point to a 1911, but rather just to get a feel of a .45 in a heavy pistol to see if I liked the cartridges characteristics...

Well as it would be, this is a cheap pos. hi-point jh45. (wanted to see how I liked the 45 before going 1911) Ive contacted them and at worst I will just sell it after they warranty it. Im more interested if there was operator error here and I did something to provoke this or if it was just...

Any experience with what causes an out of battery discharge?

Well I had a little surprise today when I went out shooting on this beautiful day here. All was going well until about the fifth magazine, halfway through it I had a normal bang...then a second one...like a slam fire, only quicker. After examining the brass in there it became apparent that this...

Thats not the stock color is it?

Should post the dyno sheet. Seems like you guys aborted the run early, is that right or does it just look wierd in the video?

How long ago did you order the clips? I was under the impression that the clips were no longer available new from the dealer.

Did you dyno it with more than 18#s to know that? How much boost were you seeing at redline? Also do you notice the car not pulling up top like the torque would suggest, or is the power more linear like the horsepower curve?

http://www.homedepot.com/h_d1/N-5yc1v/R-100594355/h_d2/ProductDisplay?catalogId=10053&langId=-1&keyword=come+along&storeId=10051 and if your wall is unfinished, just attach some braces between studs close to the bottom plate and attach an anchor there.

Some of those Lexus AFM have that adjusting screw. You could see if you have that and make sure its backed out.

If you have a place to attach a winching point on the far wall of your garage and some chain, just use a $30 come along...

So what is your paint type and method of choice?