Like I said right at the stazrt, these are just for me to see how the cr sits and how much room I have to strut/guard etc.
Im looking at these wheels
http://www.trademe.co.nz/Browse/Listing.aspx?id=105416368
At the moment Ive just borrowed a pair of these from a mate off of his drift car...
There made by RUF (porche aftermarket supplier)
There was a certain quantity of these purchased from the manufacturer before they were drilled in Porche PCD (5x130 or something strange I think) and then drilled to 5x114.3
A couple of container loads were brought into NZ and sold to a lot of...
Ive test fited 18x10" +45 offset
They clear the strut by about 10-15mm
heres a ouple of pics on the rear, only on the jack thought as didnt have any 18" tyres
Logan
the font has got plenty of clearance and could go in further
Can get full lock in both left and right, even with the lock stops removed from the back of the hubs
Logan
Same wheel on the front.
The reason it has a 235/45 on is because thats what I had sitting around in the shed.
At the end of the day I would like to run 235 on the front and 255 on the rear give or take
I only grabbed these wheels for trial fitment to see how much room I had
Im looking at...
17x10" +5 offset 235/45
trial fitment
It clears!!!
even with some of the camber wound out
about 40-50mm between the inside edge of the wheel and the strut
Logan
17x10" +5 offset 235/45
trial fitment, kust too see what will fit and how much room I have to play with
It clears!!!
even with some of the camber wound out
Logan
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.