PPS rewire/re install

[mattsplat72]

I have a PPS rack with the plugs still attached. PPs computer is still in the car. It has been disconnected since my first 7m swap in 06. I am doing alot of cornering at lower speeds and need the assist.

Going from this.

I need to make/source a plug with wires running from the B3 plug into the bay along the frame rail ( the existing body side is gone ) thus reconnecting the PPS computer to the rack via the B3.

This seem Legit?

 

[Satan]

I added a 2-wire connector and wiring to the Aristo harness, all the way back to B3. Should work the same, just a matter of how you want to route it. I did the same for the tranny's rear speed sensor. Good luck!

 

[mattsplat72]

Yeah, I have alot of factory plugs laying around from recycling a clip. I am going to just make a new connection and wire it into the B3.
Hopefully this will aid my front end to self correct. Although I think my front end alignment is off so that may factor in as well.
It is interesting the short cuts you take when swapping and have to double back and fix later. SHM