Power Expectations

[suprastroker88]

I'm starting a new project on my 1986.5 NA-T after blowing my motor. I have all of these mods and they are all being put into my car right now. I was wondering if there's anyone on here running a similar setup or maybe some veterans that can tell me what kind of power I can expect.........

Stock Internals
HKS 60mm Turbo
HKS Intercooler
HKS PFC F-Con
HKS VPC
HKS GCC
HKS EVC EZ 2 Boost Controller (set at 15psi)
HKS Racing Wastegate
HKS 3in Downpipe
K&N Intake
Walbro 255lph Fuel Pump
RC 550cc Fuel Injectors
3in Custom Exhaust with a 4in Apexi N1 Muffler
HKS SSQV BOV
Megan Racing Radiator
Dynamic Autosports Exhaust Manifold
AEM UEGO Wideband
Aeromotive AFPR (set at 35psi)
HKS Twin Power Ignition
AEM Water/Meth Kit


Took me about a year to aquire all the parts but I've finally done it and now I'm in the build process. I just want to know what to expect. Thanks

 

[hvyman]

n/a block and pistons? 30 min at most.(it will last)


if you read the water/meth thread before it stated that you can loose hp if it is not tuned correctly. why dont you tune it very correctly at a dyno and find out how much hp YOU have.

 

[suprastroker88]

No. It's a complete 7mgte swap.

 

[Poodles]

Well that's not NA-T

 

[Failure14]

Well if tuned correctly i can easily see 400+hp,

And most likely more, again if tuned correctly.

And im hoping you just left this part out on accident
but you have a MHG right?

Why did you not get any internals? pistons, rods etc.

I've heard alot of people say stock internals on a 7M can hold
a little over 500 and ive seen people a little over 500 but why
take the chance? It's obvious your going for pretty big numbers
and depending on the miles on the motor and how well it was
taken care of your having the risk of a rod being thrown or
some kind of internal failure that could possible ruin alot of the bolt ons
you just spent crazy money for...



Miles on the new motor?

 

[suprastroker88]

Sorry. Yes theres a metal headgasket. I bought the motor from my friend who use to drift with it. He took it out because his sponsors told him to go 2jz. So he rebuilt this 7mgte and sold it to me. There's 0 miles on it since the rebuild

 

[Failure14]

Sorry. Yes theres a metal headgasket. I bought the motor from my friend who use to drift with it. He took it out because his sponsors told him to go 2jz. So he rebuilt this 7mgte and sold it to me. There's 0 miles on it since the rebuild

Rebuild? What did he do to the rebuild? You said there is stock internals.

Unless he just did the MHG.

 

[Poodles]

Probably not enough boost to see a lot of power. It will take tuning to really see what it can do and EVERY car and setup is different.

 

[suprastroker88]

stock rebuild with acl bearings and a metal headgasket

 

[MRSUPRA]

I would say about 370-380rwhp at 15psi.