hey guys i just got a new motor and with my setup with the motor i got a greddy td06 turbo . i was told it was a direct bolt on but apparently its not. And other than buying the actual greddy turbo kit(which i refuse to buy the whole kit since there no point in it when i already have the turbo and everything else.) i need help figuring this out. So ive found out that the td06 uses a t3 flange but ct26 uses t2 and so i would need an adapter to mount the turbo which ive found on ebay. But i have know clue about the oil feed lines from the engine to the turbo or how to find the turbine outlet elbow since the turbo uses a different one there too. Anyone have a clue to what i could do to fab these parts, or where to find them?
How to get turbo elbow and oil feed lines for greddy td06 to mount w 7mgte
- Thread starter marcmann982
- Start date
You need ct to t3. Iirc ct is not t2 but ct size.
Custom oil lines. not hard to do if you know what your doing or if you buy the right parts.
Exhaust. Post a pic. idk what it looks lije but im sure it could be fabbed.
Option 2 sell the turbo and buy something else.
Something to consider: research. know what your buying. dont get haggled.
Custom oil lines. not hard to do if you know what your doing or if you buy the right parts.
Exhaust. Post a pic. idk what it looks lije but im sure it could be fabbed.
Option 2 sell the turbo and buy something else.
Something to consider: research. know what your buying. dont get haggled.