Search results

Great build, I like your attention to detail.

http://www.supramania.com/forums/showthread.php?100739-Removing-multiplex-from-7MGTE-for-less-than-200 Yes this is for standalone cars only, AEM.

That is the ignitor used with the IS300 coil upgrade, its what i'm running right now.

So when you say plug N play, would this setup work with the DH61 ignitor that I already have wired in and AEM?

I'm going to get another set of new IS300 coils from Driftmotion, even though the ones on it are new from Driftmotion. I have no clue what else it could be. It really seems to be ignition related. I've removed and inspected everything in the fuel and ignition system. The only thing that did not...

So I finally decided to spend some time on this damn car again. I still cannot figure out how it went from running great one night to the next morning I start it up and it misses under any load. I've replaced the cam sensor with a brand new Toyota unit, checked fuel filters(spotless), replaced...

What made you change the coil setup?

I'm using the is300 coils and ignitor. Lowing the boost doesn't help It misfires under 25% and up throttle .

I replaced the plugs again to make sure it wasn't that and also gapped them to .022" ( where they were when it ran like a champ). I just ordered another dh61 ignitor. I also took a fuel sample to check for any contamination and it looks crystal clear. I was going for the sleeper effect with the...

I need an IS300 ignitor to try swapping out with mine to see if this thing will run better. I did a compression test yesterday and all 6 cylinders are at 140 psi so i know there is good compression. This sucks, it literally started running like shit over night. I brought the car back to the...

I have the IS300 coils and DH61 ignitor

Yes its map, I'll check it out. The coils are brand new, but the ignitor was used. How do you check the ignitor?

Hopefully I can make it to the meet. The car was running fine until one morning I started it and it started misfiring. I'm bringing it to the guy that tuned it on Tuesday to try and figure it out and maybe dyno the car on 25 psi...

I didn't see any sensors acting up, I did replace my CPS because I found oil was leaking inside it, but that made no difference.

Good old Supras (loose nut behind the wheel) it started running like shit overnight. It ran fine all day, parked it, started it the next day and now it misfires under any load. It idles ok, I can even hold it at any rpm with it smooth, but under any load a misfire. I'm bringing it to my tuner...

Any of you guys in CO have a spare CPS I could borrow for a day to compare to mine. The car started running like shit out of nowhere one day. The only old/ used part on the car is an old cps I bought off the forum and I think it took a shit. I finally got a stiffer wastegate spring and this is...

No other videos yet, but I did get the 16lb wastegate spring installed. I've turned it up to about 23psi and the car gets STUPID. Its starts getting sideways from a roll in 3rd gear. I love it!

It doesn't stop pulling, even 5th gear puts you in the seat. I rev to about 6800. I may put some cams in later on. I just want to enjoy it right now I'm gonna see what it does on 25 psi, either way even where it sits now its a blast. I'm still waiting for the wastegate spring. Aaron at...

http://www.youtube.com/watch?feature=player_detailpage&v=Jhu1EYDwogE

I've got one more nice video of a 40 to 140 pull, I'll post it in a few...