Search results

sethron71 - Can you post up more pictures of the stock modified FFIM?

Does any one have any experience with SIP Racing MLS headgasket for the 7MGTE?

Just looking for a machine shop who can get the surface finished needed for a MHG. 2j route is getting more tempting..

Does anyone know of any good, trustworthy shops in Colorado? Need to get a metal head gasket installed. Thanks

I'm an idiot, I should have thought of this earlier. I jump the fuel pump check connector on the 5mge chassis harness and the car is running. Its a rough idle which might be do to the ignition timing. This isn't going to be my permanent setting, so how does the 5mge fuel pump run through...

I used a feeler gauge to adjust the TPS, but I'll readjust to make sure it's correct. For the resistor pack, you mean the EFI resistor? And I should be looking for 12v at Pin 2 black with red stripe wire with IGN ON correct? I think I might have found the culprit. Fp from the 7MGTE ECU which...

89supracrazy - I've check to makes the injector resistor pack is plugged up and resistance is in spec. I'm going to double check it tomorrow after work again. So you're saying that with out the AFM it won't rev? And with the TPS unplugged it will idle at 1500 rpms? I'm going to check that...

MINA, tried the throttle trick you suggested, no changes. The timing is correct. The ignition timing is the base setting to get the started. I can't set ignition timing since I don't have enough time to and also since I have a code 51. The pins at the ecu for all injectors were reading at...

87 auto 7MGTE swap to an 84 manual. Got the 7MGTE to start, sounds like it misses. Runs and idles fine for about 7 seconds and then dies abruptly, sounds as if the fuel is getting cut. If I give it gas, it revs to and tops off at 2000 RPM and after releasing the pedal it tries to idle and...

+1, Lafayette, 84 7MGTE

Makes sense, I'm sure you can just swap out for another tps.

What codes where you getting an what was the problem? Where did you wire the relay and fuse? How did you jump the fuel pump?

Did you ever find a solution to your problem?

Did you ever find a solution to your problem?

Did you ever find a solution to your problem?

Did you ever find a solution to your problem?

Some pics of the 7MGTE swap, almost finished.

Actually no, the supra isn't drivable yet. ---------- Post added at 03:08 PM ---------- Previous post was at 03:01 PM ---------- Here's some pics, I'm just waiting on the downpipe to get fixed by RabidChimp. He forgot to cut off piping that was extruding pass the flange.

Hey everyone, been a forum member for a while just reading up topics, but figured I would introduce myself. I'm from Lafayette, CO. I've got an 84 Toyota Celica Supra with a 7MGTE swap and tons of suspension and brake mods. Looking to post in the classifieds but I don't have permission to post?

Are the cometic mhg's the same design as the bead type?