Search results

I am in the middle of a 1JZ swap and wonder at how to get the sender off every now and again. Thanks for the tip. Mark Bottorff

I'm trying to figure out what else I need to buy to install my clutch. My 1JZ came with an R154 and an Ogura Racing Clutch strapped to the pallet. The clutch is in 3 pieces: the clutch disk, the pressure plate and a ring that goes between the clutch disk and pressure plate (not sure what to call...

The tie rod tool works on the driver side. But on the passenger side there is a bracket on the rack that prevents the tools from sliding all the way to the end. Since the engine is out of the car I took the rack to a local shop. When they took it apart we found that the seals are all blown out...

Thank you.

I found the procedure in the TSRM but I don't have the right tools to unstake the claw washer to stake the new one. And I don't a wrench skinny enough to fit in there. Does anyone have a DIY method for replacing this part? Thanks, Mark

I can't seem to find the inner tie rod replacement section in the TSRM and my Haynes has disappeared. Can someone point me in the right direction on how to disconnect the inner tie rod from the steering rack? Thanks, Mark Bottorff 86.5NA->T (soon 1JZTT)

Thanks for the warm welcome guys. After I had scavenged all the usable parts from the 88T it went to the junk yard. Then after I cracked the head in the 88T motor in the 86.5NA body I bought the 87NA for $300 plus I had to do buy and replace the clutch on the sellers car (single mom who was...

Hi, My 1st Supra was an 88T, pearl white with maroon interior and a targa top. That one spun into a rock mountain at about 50mph. My next supra is a black 86.5 NA with a rod knock, leather interior and no targa. I swapped in the drive train and interior from the 88T and drove that until the...