Search results

  1. WillieLZG

    7mgte wont rev past 5500

    Code 52 is fixed. Cleaned the sensor plugs reconnected them and reset the ecu by disconnecting negative battery cable. Restarted car code is gone started revving in neutral same issues at 5500 rpm. But found out that if I turn off the Rebic LC the car runs fine revs all the way to redline. So I...
  2. WillieLZG

    7mgte wont rev past 5500

    OK just installed inovate wideband, clean and flowed 550cc rx7 low impedeance injectors, Hks Vpc with 550cc rom(says 7mgte lrg injector on the rom), Gredddy Rebic LC (old school greddy piggyback got it super cheap like the idea that it eliminates rev limiter, boost cut, and controls fuel) and a...
  3. WillieLZG

    knock sensor rewire completed!

    I have two supras both have a had code 52 one i rewired was always on the other one is weird it shows up on really cold days maybe 5 times a year only and goes away once warm i turn it off restart and it's gone and runs great again. I even turn it off while driving, once warm i engage clutch...
  4. WillieLZG

    7m build oil

    Starting to research and preparing to do a 7m build. I have almost everything figured out except the oiling system upgrades. I've researched and read a lot and will read some more but am debating using ge block vs gte block and once I'm sure then i can move on. I have both a ge block and gte...
  5. WillieLZG

    Block Prep

    I'm currently running a toyota composite gasket boosting 15psi no problems. Have also wondered composite gaskets limits. I think almost all mkiii supra owners feel that a MLS gasket is the only solution to there BHG problems and replace it with one and find them selfs more frustrated since they...
  6. WillieLZG

    Worst driving conditions

    I live in El Paso hot as hell summers here 100+degree summers no AC worst driving condition drains you of all fluids glad my supra currently has a working AC. Does rain and snow here not much, but when it does ton's of accidents happen but because of crappy street drains water pools in roads and...
  7. WillieLZG

    Harness Bar Pics

    So it's your knees or your balls one or the other. What harness bar is safe to use and currently on the market?
  8. WillieLZG

    body moldings

    I recently bought a complete moulding set in great condition off 91 supra for $200 not bad since they are in great shape and that included the shipment from japan. Junk yards suck those assholes try to rip you off. There was a local junkyard where i live had about 40 supras about ten were turbos...
  9. WillieLZG

    You know you're a Supra owner when...

    Actually semi true story for me. She did get pregnant and yea i was too cheap to buy condoms because all my money was used on the supra. Actually she loved my supra she would even watch me work on the supra just for fun. Not even ask questions just sit on the hood of her car and watch it was...
  10. WillieLZG

    Aloha from the new girl...(slight NWS)

    No nothing wrong at all
  11. WillieLZG

    You know you're a Supra owner when...

    when your girlfriend gets pregnant and says sale your supra we need a family car for the baby and you reply i want a paternity test.
  12. WillieLZG

    Aloha from the new girl...(slight NWS)

    OHH OK let me shave right quick buy some tan in can put my boots on a nd take a pic just for you:naughty:
  13. WillieLZG

    Harness Bar Pics

    So 4pt harness no good because you will slide out but what is stopping us from sliding out all car seatbelts since since nothing is retaining us underneath anyways. My opinion is that proper 4pt harness will retain you better then stock seatbelt will. As for the titan motorsports bar i was...
  14. WillieLZG

    Aloha from the new girl...(slight NWS)

    Note to self and well everyone reading. Make new supramania account as a girl and become famous supra owner.
  15. WillieLZG

    Fresh JDM 7mgte swap new problems

    I suppose you lack a sense of humor. I have personally removed brake boosters off some of my personal vehicles and the car was not damn hard to stop. So therefore i really think something is up with his brake system and it never hurts to bleed and check all the pads and rotors. I personally...
  16. WillieLZG

    Fresh JDM 7mgte swap new problems

    Solution is simple. You need to hit the gym and toughen those legs up and so that you can have the strength to apply the brake manually. seriously though if it idles perfectly and runs good so how is it a timing issue. Also brakes don't feel all that hard to stop the vehicle when the booster...
  17. WillieLZG

    Rack and pinion

    i picked up a rack and pinion a couple years back from Autozone. It's a rebuilt stock unit and there is a core charge that will be refunded once you take in your old unit. unless you already have it off then just go to the store with it in hand and hopefully they have one they had one when i...
  18. WillieLZG

    Death&Perdition

    Well as for short term mods I ordered a NRG quick release hub and yellow PIAA yellow fog bulbs last week should be on the car within the week. In long term agenda for 2010 paint, already have a 91supra 2.5ttr jdm moulding, & a 3pc wing, and going to buy a front lip and turbo A duct. Thinking...
  19. WillieLZG

    Death&Perdition

    My first car was a NA supra with a grinding w58 that i picked up for $900. I swapped the motor to a 7mgte blew the tranny up and ended up buying another this supra that was in a whole lot better shape and swapped all my parts over. This is what she looks like to date with these generic typical...
  20. WillieLZG

    Running a 7M without the Coolant By-pass Tube

    I bypassed my throttle body and ISC valve coolant lines because i figured adding heat to them was stupid idea since you want intake air as cold as possible and i simplifies things a little. Also did the same when i removed my heater and first thought to cap them but looped a hose from the inlet...