Search results

just fitted me new aem gauge and alarm bells going off when putting me foot down.wideband gauge displays around 14-15 when tickover but when i give it some stick it travels to the left and goes straight down to 11 (the lowest reading). ive read this shows its dangerously lean and need some...

i know its the same old crappy question but im getting nowhere with the setting up. my settings are as follows - gain = 19% set = 1.74 warning = 1.20 warning L = 14% i dont understand what the set gain is and im assueming 1.74 is psi (1.2bar) could someone comfirm thisfor me and advise...

im fitting a oil preasure and rpm gauge into me dash but rather than fit a sandwich plate and relocation kit for the air filter can i use the dash wires already there via the loom pips, if so anyone know where to locate the rpm signal and oil preasure signal wires . thanks

hi pips ,just wandered where i could place some more 55mm gauges ive already got a pilor pod with two gauges (drivers side)fitted but need to fit a afr gauge .anyone fitted gauges above the glive box where the slotted heater vents go .pics would be great or ideas ,i have 3 gauges to place...

just need some advice on what fuel pump im needing as me cars running major lean, im after one that fits inside the tank maybe walbro but need to know are they the same as the mk4 pumps ,would an external pump be better ? thanks pips any links

just had me first dyno test and bit disapointed with the results ,it show that its giving 346.8 bhp wich aint bad for a used engine but the pic shows that at 70 mph the power drops off until 74 mph and then pics up again ,its also running dangerously lean and im risking the lump. dont know...

hi all, havent posted for a while due too finishing me 2jz gte swop takeing so long, now shes running sweet ive noticed that the fuel used is way too high as in im lucky to get 15 mpg and thats if i take it extra carefull,im also noticeing a pinking (sounds like a chain ) sound when putting my...

hi pips, just wandered if any one has tried dyeing there leather trim a different color ,what was the results ? ive found a company that supplts all the gear,color remover ,leather prep,colored dye and the blocker . cant make me mind up whether to go ahead with it or not so any advice with this .

hi pips, ive got a strange one for you all lol, when i start driving me car farts and cougths until she gets realy warm ,its frustrating as i cant open her up for about ten minutes or so ,ive also noticed that i get a certain sound comming out the exhaust while im waiting for it warm up like a...

hi pips, ive fitted a mk4 2jz into me old mk3 and found that with the clutch peddle off im getting a noise just like a thrush bearing,so today ive tacken the box off and found there is no spigot bearing fitted,would this be makeing that noise or do you think its me box internalls. im thinking...

ive completed me 2jz gte swop but have a noise comming from my clutch until i press on the peddle,so im guessing the pilot bearing is worn out.has anyone got the toyota part number for this and can you confirm its the 1jz clutch .thanks

hi pips ive just finnished me 2jz conversion and after 3 weeks of wiring she runs like a dream. the question i need to ask is do i need an engine oil cooler as the donner car didunt have one fitted ?

im in the middle of wiring the 2jz into the 7m wiring loom but ive noticed that the dash plugs from the donner car (1989) has a 20 pin connection plug and my mkiii dash plug has a 15 pin plug ,can anyone give me the pin wiring for both or at least one of these as im at a standstill . this is the...

hi people im sorry me first post is for answers but im going goggle eyed looking for the salutions, im in the midle of fitting the 2jz into me old mkiii but need to now about these plugs under the glove boxand where they link up to. im trying to find the progresive steering pin out and i think...