Search results

Only if we can get Mexican....or pizza. :naughty:

Definately could have been worse. Though I don't think that dent can be popped out so easily. looks like the metal has a crease or two.

I swear man- you all are trying to kill that car faster than we can ressurect it. : )

Just torque the HG as per the ARP installation instructions. Get a thermostatic oil cooler setup. Shim oil pump while you have the chance, and replace the piston squirter bolts if the internal springs are weak at all.

I've had a BHG where the cylinder pressure would leak into the cooling passages, but no mixing of oil and coolant, and no reverse of coolant into the combustion chambers.

I think he means .001x inches clearance, vs. .002x inches clearance. Sometimes, you have to file your piston rings and adjust your piston to wall clearances a bit wider for higher HP goals too.

Mine. http://www.supramania.com/forums/showthread.php?120573-Diagram-on-How-to-route-PVC-lines-correctly-with-a-Catch-Can&highlight=catch+can

Yeah- I made 261hp at stock boost. ps- I would expect you to make full boost before 4000rpm.

1ggte? Kinda rare to have the 2.0 motor. Not sure how much is here in the US for that engine. Welcome to the forums, man.

Good work. I've had trouble in the past, trying to get the ARP's out. It's like they swelled up and I couldn't lift the head off them, so i had to remove them with the head.

Hey- where's Kathleen, GA?

Yes, Mine is similar, just round. However, the best design, is to have a wall, inside the can, separating the inlet side from the outlet side, so that all air is forced down to the bottom, and then up to the outlet through a wire mesh, to allow the fumes to cool. The mesh captures the...

Eibachs here. Had Intrax, but they sat too low, and i scraped. Eibach's have a good ride and look good too- 1" drop rear, 1.5" drop front.

Also, I don't see how the coating can go from the manifold into the engine, unless you're talking about it passing through the EGR system to get there. Otherwise, the only way any flakes would be going is towards your cat.

Have you had any new codes since changing all of those items out? What is your fuel pressure showing? What mods do you have?

you expect me to believe that and old lady was trying to do a JZ swap?? Regardless, good find, man.

Yes. Or I might have some. PM me your address and I'll send what I've got, if you don't mind waiting a few days. Otherwise you're looking at like $7 or $8 at Radioshack.

If you get one from Advanced Auto parts, it IS a factory unit. It's Aisin, and they grind the name toyota off the side.

What rpm are you checking the timing at? Have you jumpered the T and E1 ports as the TSRM says? Jumping might be from misfiring. You should have fresh plugs gapped at .8mm

Mine is the headgasket. ...oh- sorry...my standard answer. I would see if you can get an adapter that goes from the accordian hose's inlet size to the same diameter as the output for the BOV. Basically- an all-metal reducer that will fit the nipple off the intake, and allow you to run a...