Search results

i was compensating for outdated 20 year old oil tolerances...lol and i was in fact "in spec" according to trsm....i was within the tolerance they give.....i was within .0005" on the tight side and .0002" on the loose side.....and a maximum clearance of .0031" id say that what i told him was...

I heard knocking.....first thing that went threw my head was "haha you got rod knock!".....

I bet you safe auto is cheaper....

its spelled "stooped"

you sure are pretty LOL

I wish I was special :(

Driveshaft....in the rear section of the DS (behind the support bearing) look at the u-joints and see if the rear is lined up with the front...the rear portions of the stock shaft is know to be full of fail as me how I know.

+1 No need to remove it compleatly...just unbolt it from the diff (4 bolts)...unbolt the crossbar thing (2 bolts)....unbolt the center support bearing (2 bolts)...let it rest on the ground with the yoke still in the trans.

naa they still good...they don't stick to the ceiling yet.....still got a good 500 hours to go yet!

I was about to ask what color underwear I was wearing...

What? I don't think I edited a post in here other than to correct spelling cause iPhone doesn't like me. Your crazy old man!

you gotta admit.......I was so very close!! And god damnit I cant kick myself

if its babbot (sp) imma kick myself in the ass!

is it an actual race?

I'm guessing the spec is around .0015" to .0028" for the bearing oil clearance on the oil pump driveshaft....don't quote me.

doubt that will happen....if I'm not mistaken its a brass bearing correct?.....he will just wipe it out and blow the oil seal....then have a mess to clean up but I don't think it will stop the pump from pumping...still not good though!!!

microscopic scratches won't hurt a thing....a glass mirror has microscopic scratches.... Its damn near impossible to remove imperfections from metal (I'm a machinist)....if he used 800 grit paper then he probably improved the bearing surface better then factory....although he should have...

.................................................. Mine is longer!

800 grit is extreamly fine shit!!! That shaft would have an almost mirror finish if he used oil with sandpaper... Bet he removed .0005" of material at the most. To the OP...how is the fit??....did it slip right in or did you still have to play with it till it finally went in?....is...

by push-ups I mean "cock" push-ups.....yeah that's right...its where you lay flat on the ground and you let your boner lift you up off the ground...yeah ...I wake up early to get started on my cock pushup routine!!!! I told you its not easy being badass