Search results

You can use an Auto ECU and Harness for a Manual - but you can't use a Manual ECU and Harness for an Auto.

Put the tools down and step AWAY from the vehicle. Seriously? :nono:

Right - you need to pull that engine. Sounds to me like you need a rebuild - a headgasket alone won't cut it. If you have Mayonnaise oil, sorry, its time to get the block cleaned, new bearings and have your crank checked out.

Oooh - very nice! Could you do us a HUUUUGE favour? Could you take pics of the ECU (& internals?) :D

Loving the Stargate reference: "Good Lord what does he power all that with, a ZPM?" :D

Line hone...just for using ARP main studs? I've not heard that one before... The less machining you have to do, the better. This isn't a Chevy small block.

And exactly where are the rest of you lot? :p

...or a sledgehammer? ;)

Shepherds Pie: You will need: Four Large Potatoes 1.1lb / 500g Minced (ground) Beef One Onion Two Carrots Two OXO Cubes or similar - http://en.wikipedia.org/wiki/Oxo_(food) 2oz / 60g Grated Cheese Butter Milk Preheat your oven to Gas Mark 5 / 375*f / 190*c. Fry the onion in a little cooking...

In with K :)

Yeah, if i had an engine crane, and the funds, i'd pull the whole lot. But, the subframe route means you can leave the engine block in the car attached to the transmission. As poodles stated, you cant pull the crank without dropping the transmission at one end, the front and rear covers, the...

...90 trim turbo? Has he stepped through from a parallel quantum reality, or is he just 14 and making that shit up?

Only need 400ppm of water in the oil to turn it into an acidic, bearing eating goo. Even if you can't see a milkshake going on, doesn't mean that there was no water in there.

Have Vonda make my cake for you. SERIOUSLY - IT'S THAT GOOD.

Hmm...thats low like mine was. Turned out to be worn bottom end & needs bearings replacement. The hose you're decribing sounds like its where it should be. You can try changing out the oil cooler pressure relief valve, but personally, i'd vote for bearings being worn to shit. Get a proper...

Hang on, i was under the impression the stocker was 1.37mm compressed?

Mocha Chocolate Sponge Cake with Coffee Butter Fudge frosting: For americans, you need SCALES to make this (none of this cups nonsense). For the sponge: 6oz (170g) Butter 6oz (170g) Sugar 6oz (170g) Flour 1oz (30g) Cocoa Powder 3 large eggs 1 tablespoon espresso coffee 2 heaped...

Hmm, this may be the case, but that would mean i have to get the subframe off, drop the sump, remove ALL the rod bearings and measure the clearances/plastigage before dropping Toyota ones back in. However, Toyota sells each bearing for about $15. Without tax.

What else could you lot be doing on a sunday? Get in here!