toyota.s's latest activity
-
Ttoyota.s replied to the thread 7M-GE Valve Shim thickness equation.Measured Clearance + Existing Shim = Existing Total - Ideal/Average clearance = Ideal new shim size.
-
TI'm currently working on valve lash adjustments and trying to figure out the new shim thickness, but I'm also making sure my...
-
Ttoyota.s reacted to 3p141592654's post in the thread 7MGE Intake tubes degree angle and diameter size? with
Like.
If the vac line is attached to the first intake tube after the air flow meter then it is the power steering idle up circuit. That line... -
TBelieve that is for noise cancelling
-
Ttoyota.s posted the thread 7MGE New Fuel Pump Hanger question. in 1986-1992 Supra MKIII (A70) Discussion.I just replaced my fuel pump and fuel pumper hanger. The new hanger comes with a third connector and a black block in the back. Does...
-
-
Ttoyota.s posted the thread 7M-GE Tips for torquing harmonic balancer on engine stand? in 1986-1992 Supra MKIII (A70) Discussion.I'm installing an ATI Super Damper on my 7M, the OEM one is rotting and discontinued. The engine is on a stand, if possible is there...
-
Ttoyota.s reacted to 3p141592654's post in the thread 7MGE Intake tubes degree angle and diameter size? with Like.
for the vacuum this may help. I think the one you are pointing to goes to the charcoal canister but I don't see the BVSV installed (23262).
-
Ttoyota.s posted the thread 7MGE Intake tubes degree angle and diameter size? in 1986-1992 Supra MKIII (A70) Discussion.Does anyone know the degree angle and diameter of the 2 rubber intake tubes? They are discontinued from Toyota for the 7MGE. I found a...
-
