have you figured out what the problem was? i have been working non stop but im gonna try to fix it again this weekend and i would really like to know what to try
so i adjusted the throttle rod now i am def sure the throttle is closing all the way but the tab on the throttle linkage does not touch the idle adjustment screw when fully closed is there a way to adjust that so the screw will actually do its job
because now the car idles so low it stalls and...
So i have a update, if i take the main vacuum line that runs from the accordion hose to the ISCV and plug it on both ends the car idles perfectly.
any suggestions on what i could do to fix the problem? or should i just run without the ISCV?
also the reason i figured this out was from watching a...
I finally got my 7mgte to start and it runs great no misses revs great only problem is it wont idle
im not sure on exact rpm because its a n/a tach and turbo ecu but it idles high and steady for a while
until it warms up then it starts hunting for a idle speed it goes from around 1000 to...
Update: so i after failing on several attempts to pull the dipstick tube out the top i decided to just do it the hard way and pull the motor. so after i got it out and the oil pan off i found out what had happened.
the guy who i bought this motor from had it rebuilt at a local shop and when they...
i have a 90 7mgte that is missing half the dipstick tube. the half that is in the block is a straight tube
about 5 inch long with no flare at the end. i have a dipstick and tube from a 87 non turbo i would like to put in but i cant seem to get the straight tube out of the 7mgte it will spin...
i just bought a 7mgte and r154 to swap into my 88 supra N/A. it had a 7mge and w-58 so i have the drive shaft from that and i also have a drive shaft from a 87 turbo with the a340. what i am wondering is if i can take the two of them and make it into a drive shaft that would be the right length...
hi i am new to the site and i needed to post quick before i get deleted so i figured id tell you about a couple projects i have going on right now
1. i am in the process of swapping a 7mgte and w58 into a 1987 toyota pickup 2wd right now it has turbo header and a cheap t4 turbo to get it to run...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.