Recent content by Slash200

Hello, is there a way to force the ECU to run allways in open loop? It would be much easier to tune with the translator pro. regards Bastian

Thanks, i wrote him a mail. I just need some photos for the welder that should built it for me.. Or if someone is selling his front facing manifold, I want it! ;)

does the 7m-flange fit on the pipes from the 1jz manifold? Have the pipes the same diameter? I can't check that atm because i'm at work. Do you have some pictures of your work?

Hello! i heard that it is possible to make a conversion from the 1JZ Intakemanifold to work with the 7M. A person in the german supra-community told me that there exists a manual for this, but i can't fount something. Does anyone have pictures what need to be welded and so on? sorry for my...

Hey Community, I'm driving since month my supra with speed density. Today I had decided to install Timing control. I Used this diagram: I desoldered Resistor 7 on the Board of the Maft Pro Unit. Now the engine runs very bad. like on 5 cylinders or something like that. thats my bin...

The cables are new ngk with ngk iridum plugs.

Hi Guys, i have a really strange problem with my supra.. Sometimes(that is only sometimes is is the strange thing) runs the engine rough. I try to explan... When i'm acceleration the engine runs rough. It feels like something is wrong with the ignition. Its not so rough like running on 5...

okay thanks. your informations are very helpful. next thing is to wire TIming control in. but i dont know how... ;)

no sorry. i received it on friday. and i was sent to germany in the february... yes, very long shipping time :D ALDL tracing is now working, but it is normal that always four Cells are highlightet? My friend got a SIMTEK ECU in his subaru and its showing a crosshair on the cell exactily where it...

My Pro Version is 5.27. Its brand new ;) okay i think will test if the VE Table Tracing on the PC is working. It think i was just to stupid to see the correct button in tuner pro ;) I got a other question. Can the Pro or Tunerpro show me the Injector Duty?

okay i will try to update the firmware. is it possible that something is wrong with my wiring? .. the engine runs great in speed density mode strange thing is that something there is a value on CEL on the maft.. but thats very rare

i think tracking is active because the Dashboard is working. hm dont what version my maft is.. it think it's 5.10 TunerProRT is in Version 4.13 But is it normal that the MAFT device show nothing on its display for CEL?

sorry my english suxx :D On the tiny display on the maft it shows CEL: 0 and TunerProRT doesnt highlight the active cell. thats my problem.

Hello. My maft pro w/ speed density dont shows the active cell in what it is running. Its always 0. Just by short tipping the throttle it shows 65. What can i do?

hm okay thats goot. but I need to change the settings from the maft pro? sorry for my bad english...