Recent content by peer648

Car have some issues below 2500rpm. Trying to eliminate possibilities. I have 840cc high imp. So I remember when buying that to run high imp injectors, removing the resistor would be necessairy. I still have it. I've done 4000km with it, mechanic said i don't need to remove it. Wanted to know...

Where's the video of that dyno pull !? Would love to see it

JNC 019 on all fours ,front 18x8 potenza 225/40 , rear 18x9 with shitty 235/40, will burn them and put 265/35

Thanks everyone ! Found what I was looking for. Bought the one on toyotapartdeals, and right after buying it, I found this, looks like there is a lot of parts available...

Is it new or good condition ?

Where ? In canada they don't have it

I contacted marlin crawler and pfitzner, they don't have that

thank you, will search for that. Any other solution still accepted !

Hi everyone, looking for a reverse gear for my r154, toyota dealer don't have that, same with driftmotion

Thanks for answering guys ! Good to know that I should be good with my diff and driveshaft. For tire I think I'll go mt et streets on 17's. Does 16's be better, would it worth it ?

Hi everybody I intend to go drag racing this summer, as soon as every little problems is solved. Nearest from where I live is an 1/8 mile. I want to go on 1/4 mile but probably gonna be on 1/8 more often. Motor is built and will be around 450-500whp. I have two R154, both with diffenrent...

My Aeromotive fpr from driftmotion ''tick,tick'' pretty loudly and kinda go a little sideways in the same time. Like a hammer was hitting the inside. It's doing it continuously. I can't remember if it was like that in the begining. Is there something wrong with it ? Does any sound or movement...

7mgte, r154 Getting ready to buy a twin disc clutch. My choice is pretty much set on SPEC twin disc clutch, got few question before committing to it. Does anybody as something bad to say about it ? What clutch material should I pick ? I want something that will hold good, ready to...

do it right, do it once... ok then, twin disc i'll go. Should I take Osgiken from driftmotion or something else ?

Please someone tell me I'm wrong ! lol Seriously, I'm looking at 500 ft-lb of torque, maybe more in few years. I need clutch that will hold good. Twin or tirple disc clutches seems like what I need, but damn... its expensives. From what i've seen it turns around 2000$ 2500$. My question is...