Recent content by Mr--Peanut

I was looking into this last night so I'll offer up what I found. You will need to align the head on the block without the studs. Then, the washers need to be put in place. Now the studs can be inserted. You will need a 14mm 12-point deep socket. It needs to be thin enough to clear everything...

Just curious, isn't it a little unfair to be comparing a 7mge to a 7mgte due to the higher compression? Or is this more of just who can go fastest on a CT-26 with no limits on the types of modifications?

I can't wait to hear what you think of the coilovers. How long do you think till its on the road?

I've recently been looking into the "gixxer_drew" setup using bilstein shocks, hypercoil springs, and a sleeve kit for adjustability. It sounds a lot like what you're looking for because, based on what people say, the combo is very smooth and quiet for daily driving, yet it also shines under...

:eek3::nuts: That's certainly worth the money

Sounds like you shoulda taken the $1000

I found the sheets to go along with the numbers ^^^^

I found these on the SM member horsepower list, not exactly dyno sheets, but I thought it might help: 6. HKS_TRD - 540whp/XXXwtq - GT35R, Motec M800, UNPORTED HEAD, HKS Cams, Greddy Intercooler, Stock intake manifold, Turbo A throttle body 14. pln - 425.3whp/XXXwtq - gt35r @ 18psi, mapecu2...

Black is tough to make look convincing sometimes, but it didn't come out half bad.

I really don't understand that video where the Synapse is always blowing air out. At idle, wouldn't vaccum want to be pulling air in through the BOV instead?

Mine has the burgundy colored interior. As far as I know, those might be the only two different colors. I don't think I've ever seen any others.

I watched this video on youtube over and over, I was surprised to see it on here. Where did you pick up your RSR? I heard they were discontinued and I couldn't find anywhere that has them in stock.

What type of exhaust are you running? It sounds really good.

I did this on an 88 door so there may be a difference, I'm not sure. Roll the window all the way down and see if you can get to the two screws. They are at the far ends of the strip. As hvyman said, you may have to take out the door panel, I can't remember if that was necessary or not, since I...

What is the actual set-up? Is it a boost actuated dump or what?