Recent content by mensrea

Hey, is your PM full ? been trying to get a hold of you via forums, and TXT.

Does anybody know where these 3 wires go ?

I'll check it out, thanks !

Got a new harness in, and now waiting on stock 1jz base map. Question, I have high imp 550s, and aem 3.5 Bar map. Can I just set those in Wizard, and start the vehicle, or will I have to change the whole map ? The closest ones I can find in there are RC Engineering 550cc (52lb) 13ohm, will they...

Were you able to fix the issue ?

I got a "new" harness that seems to be in a pretty good condition, gonna try to put it in this weekend, and than connect DLI and everything else. Hope that fixes my issue. Still need a basemap for AEM 2 thu.

it's not gonna flash, it's just gonna be red. As far as checking if it works, it would be hard, since DLI only going to AMP the voltage at high RPM, so if you put your car on a dyno, and run it, you can check before and after voltage/ohms going to the coils. As long as you have it hooked up...

Check the wiring, and fixed a couple of wires that were messed up. Still no spark. The whole wiring harness is a fu****g mess. I'm thinking that my base map could be bad. Note to self: never buy swaps done by other people.

I'll give it a try tomorrow, than post on here.

Ok, I had SAFC 2 on my 1J, I took it off, and re-spliced all the wires back together. Not sure if I did it right (was running on 2 hours of sleep). The wires on the extension are not the same color as they supposed to be, so it's kinda hard to check. Anyway, I got a base map for AEM, pretty...

I got it figured out, Thanks ! Now need to set/sync the timing. What timing light ya'll use on 1j ?

Can someone look at this .cal Cant get it to start at all.... MODS AEM V2 1J PT6265 R154 AEM 3.5 bar, AEM AIT High imp 550cc Walbro 400 (12v mod) DLI HKS 264s I had it running on DM provided stock 1J map. But since I put in 3.5BAR MAP, it stopped working. Also, I accidentally deleted provided...

Switching from SAFC 2 to AEM V2 (PNP), removed/fixed most of the wires. Engine cranks, but does not start. I have one wire left, coming out of the harness, its blue with pink stripe, it does not seem to go no where, white wire from SAFC 2 was connected to it earlier. Is that a MAP signal ? what...

I need a calibration for my 1j, damn thing won't run. AEM V2, 1J, HKS 264s, HKS DLI, Walbro 400, 550s (High Imp), 37psi base FP, PT 6265, AEM 3.5 Bar MAP, AEM Air temp sensor, UEGO, AEM 30-3000 meth kit.

5w40 is going to thin out to ~30 when it gets really hot, unless I'm wrong. I know RP did that.