Recent content by madsupra88

racepak setup ready for install!

I sell th400 kits as well ;)

Ill be using a custom cable ! the stock mkiv one is too short

Ill be using a custom cable ! the stock mkiv one is too short

PHR water neck relocation All IC piping done final layout before wiring it today -Saif

More progress. Custom driveshaft in the works, cold side piping done. all V bands except the t-bodt will have a boost brace. I did want to allow for a little bit of flex since there is no cage in the car yet. Trans cooler setup, 34 row custom dimention to fit my area along with a nice...

little more porgress trans kit is in Engine/trans find thier way home A simple frame tie/trans mount made. will have 2 extensions welded off of it as well to tie back to factory mounting. Manifold in wastegate was aining at the motor mount so it wouldnt fit. insead of custting the...

well got quite a bit done . Finished up building my friends shortblock for his Z31 (also known as the Habibi Machine and will be coming along to fl2K) . was able to finish my own bottom end is finally sealed up as well all new hardware the rear floor is sealed and painted as well...

whatsup guys, Things came up, went to TX without the car as I have been slammed with customer cars. well FL2K is coming up. I paid for the events so i guess this means the car HAS to get finished for this event lol so I started back up to get her done by next month. FL2K Prep...

half yota half GM (hybrid converter) Once I get my new mill here in the next couple weeks ill be redesigning the plate and start making them again as ive had quite a bit of interest lately. 7M seem to be the new hot thing nowadays. -Saif

If you're gonna do it, might as well do it right !! here is how the car semi sits, no engine or trans in yet and alignment way off Brakes are done My favorite part, came out very clean .

welp, i'm middle eastern with a shitty sense of humor. the name of my car is Camel SR, better idea of where this is going ? lol

now we're getting somewhere, with all the work i have going on at the shop im practically living in the shop :/ pinion bearing and solid spacer on setting preload shimmed and back lash on point pretty damn good i would say new cover on and custom stubs in place last test fit and...

more mock up, and onto the final assembly of the differential. dont worry, knuckles will be blasted and coated with new bearings , just a mock up for now. Ring and pinion New diff cover no more crush sleeve, solid pinion spacer now master rebuild kit Everything gets a nice bath...

R100 they feel pretty good out of the car, havnt driven in them yet