Hey tired guy!!! lol
I checked the CPS and it checks out!! yeah!! But shouldn't I have a ground signal on the harness? I test for ground continuity on the harness and nothing. Would that cause my Crank No start Issue? Where is that ground point?
Nope that wasn't it. The AFM swap didn't do a dame thing. What i'm thinking is that the CPS is warming up and then dies out. Because the car started then warmed up for ten minutes then cut out suddenly. And I didn't touch a thing. I'm going back to the CPS.... test, test, and test!!!
Well i reset the Ecu by disconnecting the negative battery terminal. Now i get no codes. The clutch sw isn't it. I jumped it and she still cranks and no start. Last night i reset every thing. ECU, Timing and the cps. Out of nowhere she started and ran for like ten min on its own. Then it warmed...
Cam marks are up, turn the motor over a few times to ensure the marks line up, yes!!
I thank you again for all the help. Maybe its the CPS. But it checks out. all the resistance values are within spec. but I'll check them again in the morning just to triple check. what else should i check?
Wow, my car hates me.... it was running on its own. Warmed up for about 10min then it cut off. died!! Tried to start again, nothing.... i have some feeling I'm getting closer.... just all i need now is a supra whisper so they can tell me what to do!! lol WTF!!!!!
This car is going to be the death of me. If it were human being i would have kicked it in the nads by now...
Its idling at 700 rpm and holding. the cps has no cover and its cold out. I have no timing light I'm getting one tomorrow... no codes, just flashing... now i'm afraid to shut it off. it...
DMM? Yes.
I'll reset the codes now.
I did drill out the J-pipe on the fuel line.
Injectors wiring? I'll check...
pistons .40 over...
new plugs, bosch coppers...
firing order 1.6.3.4.2.5. ok?
good fuel just filled it.. 91 octane...
When cranking I can smell fuel..... faint though!! not like its...
some how i knew you'd catch that;)
well I'm done. its on TDC, the crank is on zero, the cams are lined up, and the cps looks like the one from the sticky post. It will sputter and rumble. The motor really tosses around!! the RPM needle moves up about 50-100. It will do the same with the AFM...
Sorry, I alway refer my cars as females. Just Habit!! Plus, I'm a former Marine. I am crazy... lol
OK, yesterday the car started with me just changing the plugs. That was once..
Now, I reset timing and it started up. But it was bogging out. I would hit the throttle and it would die. then I...
Well I played with the timing. I realize you haven't answered back because the info to set base timing is on the site. But I re set and she started but she ran like crap. Then i turned her off. Tried to get the CPS bolt in the center. Not easy!!!!! Well, 2 hours later all she can do is spit and...
Also, I'm kind not completely clear with tsrm. When to cam lobe is up its no where near Zero on the crank. But if i put the crank on Zero every thing lines up.
she runs good. She only boosts about 5 pounds but i'm thinking its because of the boost controller that is turned off.(old school hks B.C.) The only code i'm getting when I jump it is Speedo code 42. Weird... what does that have to do with starting.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.