Recent content by jkendall86

Update...better late than never....when I replaced the plug for the Crank sensor that the wiring specialist had cut and taped up, I did not wire in the 2 wires to their respective ecu locations. I swapped the two wires and the CEL, cam/crank sensor error dissappeared....Thanks to Arvin...

Thanks for all who replied..abs light fixed...replaced the tailshaft with one from the mkiii, used the 32 tooth pickup wheel, used the mkiii speed sensor and ran the three wires to the b3 plug... Sent from my XT1254 using Tapatalk

41...88 burgundy/na/w58...$old 42...91 white over red/turbo/r154 parts 43...87 pearl white/HT/turbo/auto...$old 44...93 sc300 blue/2jz/auto...$sold 45...86.5 white/HT/turbo/w58 46...87 plasti dip shell/HT...parted...$old 47...87 black/Targa/turbo/r154…$old 48...90 burgundy/Targa/2jz/R154…$old...

See if this helps... http://www.celicasupra.com/forums/showthread.php?33827-Hoses-Thread-(thats-hosers-to-you-Canucks-eh-)#/topics/33827?page=1 contact me via text...503-930-7268

Iacv contact me via text...503-930-7268

Destrux, thanks for the info on the speed sensor...Curious if you know where to find the wire to repin...Maybe a pic of which one and where it should go...Thanks.

Thanks for the timing tip...I rewired all three being careful of polarity, but I will check that again....As for the belt, I also have timing at 25° so that seems likely as well....I'll check that again also. contact me via text...503-930-7268

That's good to hear, thanks for the reply...I seem to have decent idle, a bit high but strong....Will i need to insert the speed sensor into the trans and run the wires to the body plug as well, or will the cluster wire suffice? contact me via text...503-930-7268

http://www.toyota-supra.info/forums/mkiii-supra/21057-converting-engine-wiring-harnesses-between-yellow- contact me via text...503-930-7268

Update...Swapped out old cam sensors for new...Still have the code...To review, that's new cam, crank wiring and sensors...Still have code 13...Seems to run just fine...Light concerns me, and drives me crazy...

My speedo works fine...it's the stock mechanical one from the mkiii contact me via text...503-930-7268

There was an electronic speedo gear that I removed and replaced it with the mechanical gear driven one from my mkiii trans, it fit right in...ad for the speed sensor, right below the speedometer gear is a two wire plug with yellow and black wires that is plugged into the rest of the trans...

I have a couple of issues with my swap I'd like to get done help with...yes, I've searched and studied. 1989 original auto turbo, swapped with 1jz and soarer auto trans with harness. My ma70 chassis has abs but the harness and trans do not. I replaced the electric rear speed sensor on the...