Recent content by gurov

not open source like that, but not the most expensive thing out there, come by speeduino/rusefi discord, we can chat.

These are not fully plug and play units yet, but maybe someone wants to help. And this post is intended for anyone who's heard of speeduino/open source ECU in general. would prolly be good for swaps i just made one with the toyota 120 plug that's on supra, sc300, and a bunch of other 2j...

for the resistor box ? there would be 6 - 12 pins/wires/some kind of connector on it . is there ? ---------- Post added at 11:33 AM ---------- Previous post was at 11:24 AM ---------- it's right in the middle... with what looks like an 8 position connector, one thick white wire and 3 visible...

they're looking for the resistor box for the injectors. low impedance injectors are 2-3 ohm while high impedance injectors are 12-13 ohm. i'm not sure what the stock setup is on the 7m, but from my limited poking around of the 2jz engine management, the stock injectors are low impedance, there's...

neat... depending on the stepper motor style, i guess you could make use of the generic PWM output feature in MS3: ---------- Post added at 04:05 PM ---------- Previous post was at 03:58 PM ---------- i guess while i'm on topic of ms3, here's a few other neat things that i found could be...

eh, i'd rather keep the 12 tooth on there. i don't think i'll do sequential ignition, for now i tried firing the stock coils paired in like throws (1 6 ,2 5 , 3 4) using logic level (low current +5v square wave) outputs to the stock igniter off the front 3 LEDS. and that worked fine, but...

howdy, i'm obviously new here, just looking around for info, maybe pick up a few used parts that people might be selling, perhaps in the shape of a not-too-banged-up-exhaust. car is a white 1994 twin turbo targa, body has 277k miles, engine is out of a 97, i believe, with 170k-ish miles...

oooh, megasquirt discussion :D. i just got done installing ms2 (3.0.3t with some mods in the code) on my mark4. Zeal engineering dual VR board for the crank/cam input (dual wheel 12 crank teeth, 1 cam tooth). using fields patch harness. sharing coolant temp sensor, and i put an open element gm...