Recent content by Cliff

  1. C

    Any one in MA? Looking for a water valve VSV

    Thanks for trying
  2. C

    Any one in MA? Looking for a water valve VSV

    What rust the moulding is plastic
  3. C

    Any one in MA? Looking for a water valve VSV

    Yes the body molding- Color is red--Attached if you can open it is a pic from the damaged panel
  4. C

    Any one in MA? Looking for a water valve VSV

    Thanks for the offer but already ordered the Prizm valve. Do you have any other parts? Looking for a left rear 1/4 panel trim strip for an 87. Not sure if the same for other years.
  5. C

    Local member with MAFT Pro experience?

    I'm a rookie at this but is MAF = mass air-flow sensor (air flow meter)? If so I thought I had a real problem with the turbo sputtering out when pressed-thought it was the air flow meter but after a smoke test of the air supply system found out it was a only a recirculation pipe below from the...
  6. C

    Any one in MA? Looking for a water valve VSV

    It's located on the right side of the firewall-I understand (from the forum) that you can adapt a Prizm heater valve Part #74850 for about $40 so I think I'm all set
  7. C

    Any one in MA? Looking for a water valve VSV

    The water connection on the valve broke off-has anyone repaired the stub water connection? or is it a replacement issue?
  8. C

    Electrical Raceway

    Is there an after market source for the plastic (PVC or PE) rectangular raceway (approx. 12" long) between the timing belt cover and the ignition coil cover? Mine has tuned to weak flakes of plastic. Just use split wire conduit?
See more
Top Bottom