Recent content by airbats801

looking awesome. Any chance we will be seeing a pdf version? :) Gonna be handy tossing it on my old laptop and using outside when working on the car.

should start a torrent for it. Glad to see someone is translating it so I dont have to :icon_bigg

just go to your local parts stopre and ask for .001 to .003 plastigauge clean your crank journals up nice and good, and toss some std bearings in and put some plastigauge on the crank in a few areas on each journal. Assemble to spec then disassemble and see what the results are. there are...

could buy some std bearings and do the ol plastigauge method and see if anything is out of spec. Thats the only way without some micrometers that you will be finding the clearance

A 1jz can be made perfect but you cant take the stupid out of the driver lol. Haltech baby ;) Seriously though, I've been tossing around the idea of a 2jzgte head on the 1jz since it has equal ports. I dont get the mismatched ports. Maybe it helps build boost quicker on those stock twins...

shit, check out my 4g63 powered 91 subaru legacy wagon :) http://www.nwstarquest.com/4g63-front.jpg http://www.nwstarquest.com/4g63-top.jpg

btw im looking for 1j not 2j manifolds.

btw mark, I may need one of those adapter flanges for the t4 to t3. Shoot me a pm and let me know what it would cost. Shaun

alright looks like they still make the housings http://www.bullseyepower.com/u_turbine_housings.asp TMH1 Mitsu Inlet, Holset CHRA HX-35 External TMH1 Mitsu Inlet, Holset CHRA HX-35 Internal TMH2 Mitsu Inlet, Holset CHRA HX-40 External TMH2 Mitsu Inlet, Holset CHRA HX-40 Internal

I'll ask dj, its from bullseye, whatever that company is, but he says it isnt listed anymore on their page. Also I believe he said it uses a mitsubishi flange. I dont think he really lost much for torque considering the chararisitics of the engine. it uses a 100mm stroke so it isnt a high...

I have the whole damn thing that sits on the engine.

I have one laying around I could probably sell for 10 bucks plus shipping. I went with a 2jz setup as I cant even fit a flex fan in my conversion.

What ebay seller do you guys recommend for a t4 manifold off ebay? The cheap chinese ones that is. I'm looking to get a new setup going for my engine.

btw, just for some extra reference. dj over at projectzero g is running a hx35 with the 9cm housing and this is what he said it spools like running on a 2.4l 4g64/4g63dohc setup/ With the HX35 on the 2.4L I was getting about 4psi at 2500rpm and full boost of 15psi at 3000rpm with FP3 cams no...

Damn mark, giving me some motivation to ifnish my swap. I think im ditching my twin 14b setup and will be doing this instead. Definately a lot less fabrication and plumbing :biglaugh: Anyhow, I'll probably ring you tomorrow, I'll be needing one of those t4 to t3 adapters.