Recent content by adam8103

If you were checking for continuity you wold get Ohms not Volts. anyways i have a 1jz vvti and in the check connector in engine bay (located on intake manifold) i know there is also a wire for CCo it might be where it is going only. I know i am cancelling it. i am doing my harness right now and...

Thats alright glad you bought it for yourself... because i found a complete manual for sc300 online, for free... and for what ever else than the wiring i do not really need the manual. all my pinout is written up on Club lexus for all the research i have done i spent a lot of time writing it...

I do not have my old harness. I am even more lazy than that, what i was hoping is someone that already have the pinout to give it to me. but it seems that no one has it.

Finally this 2nd ecu throttle control is for trac control. so i just need 92 sc300 body connector pinout and the 1jzgte vvti ecu pinout for the 2 body connectors

Hi, i am looking for a wiring diagram for the 1jzgte vvti i just got. i do not know from what car it is out of, i read that it could be from a JZX110 markII or a verossa since i got the throttle control ECU (drive by wire) but then again if i look up the ECU number it tells me the JZX100 from a...

Hi, I have a lexus sc300 with my na-t setup, I replaced the distributor for the mk3 cps, I have TT ignitor, TT coil pack, aem ems 1101. I dont get the stat sync signal on the aem ems coming from the cps, i read a lot on it but i dont find the right anwser. I need to know the exact wiring for the...

I forgot to ask, are you still running the distributer? did anyone already compare mk3 vs sc300 engine bay... i wonder if i will have enough space in the sc300 to do the same as you did to the turbo mani with my gt42

With the angle cutted on the flange to tilt the turbo towards the engine it probably made the hole of the flange bigger? or it is not as big of an angle to open these hole enough? what is the angle you have the flange cutted?

All right ! my personnal laptop is broken now, but as soon that its fixed ill post em up... because i am restricted on the one at the job

Hi i am a noob i have a sc300 5 speed and my started project gt4202 should be running for the end of the summer i live in Windsor, Ontario, Canada.